Shorty's Discussions (16)

Discussions Replied To (14) Replies Latest Activity

"Found*"

Shorty replied Dec 10, 2014 to Passenger floor pan plus some

10 Dec 10, 2014
Reply by Shorty

"Unfortunately the limo is different... I have find a lot more info since then. I'm a…"

Shorty replied Dec 10, 2014 to Passenger floor pan plus some

10 Dec 10, 2014
Reply by Shorty

"From what I have read the 75 series formal limo like I have, shared a lot of similar…"

Shorty replied Aug 3, 2014 to Passenger floor pan plus some

10 Dec 10, 2014
Reply by Shorty

"That Sounds Great... as far as replacement panels I cannot find any difference betwe…"

Shorty replied Aug 3, 2014 to Passenger floor pan plus some

10 Dec 10, 2014
Reply by Shorty

"Jason let me know if you have a section you would let go for a decent price. I might…"

Shorty replied Aug 3, 2014 to Passenger floor pan plus some

10 Dec 10, 2014
Reply by Shorty

"Unfortunatly... Yes. One of previous owners zip screwed thin galvanized metal over t…"

Shorty replied Aug 3, 2014 to Passenger floor pan plus some

10 Dec 10, 2014
Reply by Shorty

"Yeah, I still have the 429 and hydramatic that came out of my car"

Shorty replied Aug 3, 2014 to 500 Swap into Commercial Chassis

14 Aug 3, 2014
Reply by Shorty

"that's awesome man I can see from your other post you got lots of good stuff... and…"

Shorty replied Aug 3, 2014 to 500 Swap into Commercial Chassis

14 Aug 3, 2014
Reply by Shorty

"From what I have read it says I need the front piece from the 65 driveshaft like men…"

Shorty replied Aug 3, 2014 to 500 Swap into Commercial Chassis

14 Aug 3, 2014
Reply by Shorty

"Jason... as soon as I can get some money together I am very interested in grabbing t…"

Shorty replied Aug 2, 2014 to 500 Swap into Commercial Chassis

14 Aug 3, 2014
Reply by Shorty

RSS

Photos

  • Add Photos
  • View All

Forum

Bendix Power Brake Unit Power Section

Started by Mathis Richter in 1963/64 Cadillac Specific Discussion. Last reply by Chris Codd yesterday. 7 Replies

Hi,I have a huge problem my POWER SECTION of the ``Master-VAC Power Brake unit 9´´Diameter ´´ from Bendix is Broken and I can't open it to replace al the rubber parts did some of you have auch Power…Continue

Third brake light -help please.

Started by paul k in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge yesterday. 8 Replies

Did anybody from the club install third brake light in the rear window in his Cadillac? I have problem to figure out how to do it. Can I just run wire from break pedal switch and second wire connect…Continue

Extra speakers in the cadillac.

Started by paul k in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies

Ok, I have another question. Since I will run wire for a brake light I might run speakers wires.I would like to install 2 extra speakers or maybe 4. What is best option. I do have 2 speakers already-…Continue

429 and 400 trans. for sale

Started by Mark C Bills in For Sale. Last reply by Tony and Ginny 429 on Monday. 6 Replies

I have an excellent running 429 with 400 trans.recently removed from my 64. It has electronic ignition, new water pump,new fan and clutch(not pictured),new fuel pump,Holley 650 vac. sec. carb. with…Continue

Blog Posts

1964 Cadillac Fleetwood sixty special / transmission dipstick needed

Posted by Pablo on September 20, 2020 at 9:57pm 1 Comment

How are you doing folks, I’m looking for a transmission dipstick, any info I will appreciated, thank you very much

1963 Cadillac hood driver side hinge

Posted by Steven on September 16, 2020 at 9:23am 1 Comment

Hello,

 Does anyone know were I can buy a 1963 Cadillac hood driver side hinge or is there any other hinge that would fit? 

Thanks

Steven

Bad Guage?

Posted by Karl Schwarz on August 26, 2020 at 3:08pm 6 Comments

So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It  it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…

Continue

Website

Posted by Fritz Seitz on August 11, 2020 at 2:35am 0 Comments

I have been working on a website-----www.fritzsautorepair.com-----

Does anyone have suggestions?

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service