Frank Puma's Discussions (11)

Photos

  • Add Photos
  • View All

Forum

power window issues

Started by Ryan Frawley in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 10 hours ago. 7 Replies

Hey all, new guy, as you can tell because I'm going to be asking a question that's been answered a hundred times. Been looking for a while and I can't seem to find anything in detail.I have a 64…Continue

Wits end!

Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 13 hours ago. 30 Replies

Well,  after the tire change, car running good......... then on a pleasure cruise for abour 35 miles to my destination.   25 miles in, back end vibration came back home to roost.  I was goung 55 to…Continue

Wanted

Started by James jacques in Wanted to Buy 18 hours ago. 0 Replies

Looking for 1964 coupe passenger front window and driver side fender molding 786-314-1360 jamesContinue

Blog Posts

64 Power Seat Transmission cleaning-it did the trick

Posted by Norman Silverman on June 16, 2018 at 5:36pm 4 Comments

Hello All.

I thought I'd post a little encouragement for those that might have an inoperative 6 way power seat in their car. The fix is relatively easy, and VERY cheap.

I just purchased an original (not re-painted, nor reupholstered) 64 Sedan De Ville 4 window. When I purchased it the front seat was adjusted forward and tilted down in front; two of the worst positions for me, so I had no choice but to attempt to repair it. 

Pushing the switch in each direction brought…

Continue

Driver side door panel removal

Posted by Anthony Boles on June 16, 2018 at 9:32am 2 Comments

How is the door panel taken off to access the wiring harness 

Driver side door panel removal

Posted by Anthony Boles on June 16, 2018 at 8:16am 0 Comments

How is the door panel taken off to access the wiring harness 

429 Main Bearing location

Posted by Dave Fundaburg on June 6, 2018 at 8:11pm 1 Comment

I saw this question asked in 2012 but did not see a definitive answer to the question so here goes. The new main bearings I received for my build are little different than the originals. Of the five bearings the thrust bearing is the same as are two of the other bearings. Of the other two one has two oil groves and one is wider than the others. Does anyone know where the odd bearings go. My guess is they go in the front and the rear but I don't know what one goes where. Any information would…

Continue

Videos

  • Add Videos
  • View All

© 2018   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service