1963/64 Cadillac Chapter September 2018 Newsletter Posted

I have just completed and posted the September 2018, 1963/64 Cadillac Chapter Newsletter to our newsletter page at www.newsletters.6364Cadillac.com.
You can also access it by clicking on  September 2018 Newsletter.

This newsletter includes:

- My Director's Message
- Chapter Updates
- Calendar of CLC Events
- Cadillac Fall Festival Schedule
- From the Vaults: 1964 Cadillac Accessories Brochure
- Member Spotlight - Bill Harrison's 1964 Fleetwood Eldorado

- Member Classifieds

Views: 79

Reply to This

Replies to This Discussion

Note: As part of our Sept 2018 Newsletter, I included scans of the 1964 Cadillac Accessories Brochure.

You can also access it as a PDF version of it at this link: https://app.box.com/s/8rlc4d601mcrpcdb4jvgic6p08wb4z2i

It is also available on our Literature drop down menu in the main header as seen below at bottom of dropdown:

  Liking the wire wheel look on this Eldo kinda gets me thinking about putting some on mine .   Very nice car. 

Thanks for that Jason, a good read as always and I especially enjoyed the brochure formation. Wouldn't you kill someone just to acquire a full set of those cleaning product tins and stuff.

Bill's 61 Eldo looks gorgeous and is a credit to him. If I was to change anything on that car, it would be to remove the club badge off the grille. Don't be insulted and nothing against the club, but I just think the round badge spoils an otherwise, perfect grille....., what am i saying, make that a perfect car . 

RSS

Photos

  • Add Photos
  • View All

Forum

Center bearing - replacement.

Started by Anders in Restoration Discussion. Last reply by Norman Silverman 6 hours ago. 23 Replies

Had some sound from the propeller shaft and as the rear wheel bearings just been replaced I thought it would be the center bearing. Removed the propeller shaft and checked the center bearing (as per…Continue

The Central Florida weather could just not get any better !!

Started by Tony and Ginny 429 in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 7 hours ago. 1 Reply

No Description

Wanted: retaining clips for dash pad legs

Started by Mark Geertsma in Wanted to Buy. Last reply by Russ Austin 14 hours ago. 1 Reply

Looking for the retaining clips (L+R) that the "legs" of the dashpad snap into. Mine are missing. Continue

1964 429 & Trans For Sale

Started by Russ in For Sale 22 hours ago. 0 Replies

Anyone in need of a 429 & trans? Was running when pulled from car but had low compression on a few cylinders if memory serves me right. Engine/trans are in Phoenix. Russ, 562.858.6926Continue

Blog Posts

64 Recirc/Fresh Air Door Actuator replaced; FROM THE INSIDE.

Posted by Norman Silverman on February 4, 2019 at 11:21pm 8 Comments

I am happy to report that I have successfully replaced the Fresh Air/Recirc door actuator that is located on the blower box-and have done so without having to remove the blower box. I did it by taking out the glove box and attacking it from the back.  It took several days, LOTS of patience and some band-aids, but it is done. THE most difficult part -BY FAR- is to remove and then replace the screw that sits on the actuator arm, connecting it to the fresh…

Continue

Flashers

Posted by Mike Petrey on January 13, 2019 at 12:25pm 7 Comments

Where do the flashers go in my 64 Deville Convert.  I'm thinking that's why both turn signals stopped working.

Source for Motor mounts and Trans mounts 1964 SDV

Posted by Norman Silverman on January 9, 2019 at 4:23pm 4 Comments

Hi.

Where is the best place to purchase good quality motor mounts/trans mounts for my 1964 SDV? I see that Rock Auto has them for $8 and change, and others for $24 and change. Big difference. Is there a better place to buy them from?

Thanks

Norm

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service