Anyone in need of a 429 & trans? Was running when pulled from car but had low compression on a few cylinders if memory serves me right. Engine/trans are in Phoenix. Russ, 562.858.6926

Views: 159

Reply to This

Replies to This Discussion

Bump... Anybody... If not it's going to the recycler. 

.030 over 472 swap complete. Worst engine swap ever...

Phoenix AZ?  I'm in Tucson, how much is it.

Yes, it's in Peoria. Price - give me a fair offer of what it's worth for someone who wants a 429 and trans for a rebuild. It ran and I drove it from Long Beach, CA to Flagstaff, AZ. Leaked a ton of oil. If memory serves it has an aftermarket carb and the stock carb. Low compression on a few cylinders. 

A trans guy I know wants the adapter between the block and trans but if somebody wants the whole engine/trans and can use it post rebuild, great. Shop is open 7-5 M-F so would need to arrange pickup during those hours. Shoot me a text, thx  

Shoot me 

RSS

Photos

  • Add Photos
  • View All

Forum

looking for a 429 heat riser and cruise control unit

Started by Christian Doerk in Wanted to Buy. Last reply by Kurt 37 minutes ago. 1 Reply

I am looking for a functioning heat riser valve and a cruise control for a 1964 Cadillac.In principle, the heat riser flap does not have to work. It is only important that the spacer / housing is not…Continue

Tags: exhaust, riser, heat, control, cruise

Winter time cruise in Australia.

Started by Kevin Campbell in General Discussion. Last reply by Jason Edge 2 hours ago. 3 Replies

The weather here in winter is great for a Cadillac cruise.Continue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge 2 hours ago. 1 Reply

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Free 1964 parts before I throw them out

Started by Preston Bealle in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin yesterday. 7 Replies

I have front brake drums and discs, a window, a window frame, and an air cleaner shroud. I don't need them and anyone can have them for shipping cost. I would guess the shipping would be $20-25 for…Continue

Blog Posts

64 Power Servo vacuum leak

Posted by Kent Prows on June 27, 2020 at 4:02pm 0 Comments

I finally got around to fixing a leak in my heater core.  I decided to check to see if there were any other obvious issues while I had everything torn apart.  When I put a vacuum directly (bypassing the transducer) to the power servo it gets to about 10" and then slowly leaks back to zero.  The fan will not go to full and the mode door will not open completely.  I have read a couple of other posts that said they repaired the power servo leaks.  How?  Does anyone have one to sell?  I just…

Continue

63 Caddy Horn

Posted by Robert Alan Shannon on May 27, 2020 at 9:25am 9 Comments

 Just noticed a 1963  Caddy trumpet horn on Ebay. No part # given but some of his other items are 1963 specific, just throwin this out there, I have no connection to this listing .

Wiring connection help.

Posted by Jimmy Davis on May 24, 2020 at 9:15pm 2 Comments

Can someone help me figure where these connections go? I have a 64 60 special if it matters.…



Continue

Wood grain finally done.

Posted by Jimmy Davis on May 20, 2020 at 4:57pm 3 Comments

After years of wanting to, I finally redid my wood dash paneling on my 64 60s. Not too hard to do either.…

Continue

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service