Hey guys I'm another new guy here I'm sure I'll be asking lots of questions as I can't find a ton of info out there on any of the other Cadillac sites. This site has so much amazing info if I missed a post about this just let me know. I have a 64 75 Series Limo that I am building. The original 429 is done cracked piston and has been sitting with the head off of it for a few years. I have a 76 500 that I'm currently building to drop down into the car. I found one write up about installing a neWer motor into a 63/64 car... but the info was very vague and definitely had no information about the commercial series chassis. I know I need to find a new work th 400 to go with this motor sincere or no adapters available for my older Hydramatic . I also read that I need to find a front driveshaft piece from a 65 limo to make my combo work. does anyone else have any information about what all is needed for the swap. I am one of those guys that likes to have all my research done before I attempt something. I have two welders and a garage full of tools to get the job done just trying to get some pointers in the right direction!
Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light? Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue
There seems to be growing interest in the poly bushings. In order for me to keep track of who wants bushings, please send me a message along with or in lieu of a reply to either this thread or the…Continue
I need a used convertible boot for a 63 Cadillac convertible - condition or color is not an issue since it will be used as a pattern for making a new one. One from either a 62 series convertible or an Eldorado would work. I know I am searching for hen's teeth here... but you never know unless you ask!
Want to find a good straight dent free rear side trim for my 1963 Convertible. I have both sides but they do not match. Wanting to get them to match. I am attaching a photo of the two trim sided that I have really wanting the squared off trim if I can get it. Let's see what you have,…