Got cover off of engine from car.  Water pump has the smaller propeller as in the gates models.  And, as you can see in picture, the propeller is set deeper into the cavity than the new pump.  [See  pictures].  However, the new pump has the propeller that is shown in owners manual..  

And,,,the new WP is significantly heavier.

Would the raised propeller cause any concern.

I never had a cooling issue w the one in the car that i just took off.  

The cardone unit that has been previuosly suggested is not available, at least were i hv looked.  Rockauto, canter. Etc..and has the larger propellar.  The new unit does not make any contact to the mating surface and spins freely.

Also put pictivre of timing chain as well for information.

Views: 129

Reply to This

Replies to This Discussion

I had sent him a picture of the new pump offset a while ago, and he thought it was fine, that was before I saw how deeply inset the old pump prop was vs the new. And the weight ddifference Just thought I'd throw it out as part of the journey.

Yes, I knew the engine had been rebuilt about 70k miles ago, 20 years I think.

The replacement pump looks fine.  The front engine cover has the recess where the impeller sits.  Bolt it up and spin the shaft to verify the clearance. 

RSS

Photos

  • Add Photos
  • View All

Forum

Radiator Re-core PLEASE HELP

Started by Scott Santora in General Discussion. Last reply by Dennis P. DiBari 9 hours ago. 4 Replies

I could use some confirmation. I sent out my radiator for my 63 De Ville to get re-cored. Several weeks later, when I went to pick it up from the service vendor, I noticed a large amount of green…Continue

Trivia #29 - What Movie Is this?

Started by Jason Edge in Trivia. Last reply by Cees de Bunje 19 hours ago. 13 Replies

It has been a while since we did some trivia and I was watching a movie last night and saw this 1964 Coupe de Ville that briefly makes an appearance.   The Trivia Question is: What Movie Is this?…Continue

1964 Floor braces rot

Started by Todd Fox in Restoration Discussion. Last reply by Todd Fox yesterday. 2 Replies

Has anybody in here found a good supplier of replacement floor braces for the 64 convertibles. Continue

Tags: support, brace, Floor

Nice 1963 to 1967 Cylinder Head Water Outlet Pipe Assembly - $150

Started by Jason Edge in For Sale yesterday. 0 Replies

I just pulled a very good Cadillac Cylinder Head Water Outlet Pipe for cars with AC with the extended arm for compressor. That came off a running parts and is a nice piece. Included is a new 180…Continue

Blog Posts

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

'63 Eldorado trumpet horn + 2 standard horns restoration

Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment

My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns. 

There is a restoration service called The Horn Works who my son…

Continue

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service