A Mario Andretti Quote !
In his formula one race car with his helmet on —-
“ If everything is under control — you are not going FAST ENOUGH !! “
The Super Italian —Does sum that up !!
Enjoy
Photos
Members
Forum
fuel pump
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Anders 1 hour ago. 4 Replies 0 Likes
I am gathering up some stuff to put away for the potential trip home in oct/nov from MT to MS in the 63 cdv.i thought a fuel pump may be a good piece to have nearby, Are the newer ones like you can…Continue
off the wall question
Started by James Fejerang in 1963/64 Cadillac Specific Discussion 1 hour ago. 0 Replies 0 Likes
Could anyone please tell me why on some models of the 64 devilles, the Bezel, Turn signal (LH upper) is clear and the other one RH Bezel is chrome. Sorry if this is a stupid question, but i have…Continue
rear seat speaker grill
Started by Kenneth R Hudgins in 1963/64 Cadillac Specific Discussion 10 hours ago. 0 Replies 0 Likes
Looking for a rear seat speaker grill for my 63 EldoradoContinue
Classic Cadillac Parts For Sale - Misc Items
Started by Jason Edge in For Sale. Last reply by Jason Edge yesterday. 159 Replies 12 Likes
I have posted a few Misc items over on my Classic Cadillac Parts Facebook page at…Continue
Blog Posts
Starter Solenoid replacement-how difficult? Where to buy?
Posted by Norman Silverman on August 20, 2019 at 8:24pm 8 Comments 0 Likes
Hello All.
I believe the starter solenoid has gone bad in my 64 DeVille. When I turn the key, often all I get is a click, then if I try a few times again the starter turns perfectly. All battery cables are on tight and the battery is good. So, I believe this problem is the solenoid. Where do I buy the right solenoid and is it necessary to remove the starter in order to swap it out? …
ContinueFrame Markings
Posted by Gene McIlroy on August 12, 2019 at 6:26pm 1 Comment 0 Likes
Just got my frame back from powder coating so thought I would post photos of the front and rear frame markings.…
Lining up the drive shaft
Posted by Dominic Salemi on August 12, 2019 at 5:47pm 2 Comments 0 Likes
Can anyone shed some light on how to position the complete drive shaft in the correct position? I want to make sure my drive shaft is installed properly.
Thanks
Dominic
Upper A Arm Rubber Bumpers
Posted by Gene McIlroy on August 12, 2019 at 1:30pm 3 Comments 1 Like
I have found a very good replacement part for the Upper A Arm Bumpers. The top part is identical to the originals the bottom can be used as is or after a few minutes with a belt sander can be ground to the V shape as the originals were. The replacement bumpers are for a 2001 to 2005 S10 Sanoma or Blazer. Part number is on the box in the photos. First photo is the box next to the box is the S10 part and an original. Next photo shows my sanded down part next to an original.…
ContinueEvents
© 2019 Created by Jason Edge.
Powered by
