looking for 3 of these clips, anyone know where I can find them ?

Views: 68

Reply to This

Replies to This Discussion

Joe, I am a computer flunky , so I can't post a link, but Ebay seller savetheclassics sells electrical connectors like that & he's in Florida. HTH.

you can get the terminals on Amazon (CLICK HERE)

you can get the plastic shells online (CLICK HERE)

if you google gm 56 series terminal, lots of sources will come up.  The company that manufactures them is AUVECO, they have lots of distributors nationwide, Fastenal is one, if you have one nearby, they can source them.  Here in the northeast US, Napa has them in stock or in their warehouse locally.  
you can also try googling auveco part #s:

8777- male plastic shells
8775- female plastic shells
15956- male terminals
15957-female terminals

I did find them on ebay by that seller Robert,  but I felt $5.99 each was a pit pricey. After going through my stuff I found some female clips with Plastic covers. And bought 1 male on Amazon. So thank you both Robert & Mark.

get a box of the terminals, male and female.  I bought a bunch twenty years ago, probably two hundred in total, never at a loss now, it was a great investment in the longevity of my cars.

Bro, I have all that stuff at dirt cheap prices. Its not new, but its still good as new.



  • Add Photos
  • View All


Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge 4 hours ago. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Battery, alternator not charging

Started by Keith Benning in 1963/64 Cadillac Specific Discussion. Last reply by Keith Benning 13 hours ago. 10 Replies

Hello All, after replacing the voltage regulator, alternator, checking and replacing wires to alternator plug, test voltage on battery, good, voltage on alternator good.  Checked ground with multi…Continue

'64 Cadillac speedometer cable - transmission to cruise control box

Started by Don Moyer in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 18 hours ago. 3 Replies

Hi folks - I'm new to this forum, but have owned my '64 convertible since 1993.  I recently replaced the speedo gear and seal in the transmission due to fluid leak, and noticed that the end of the…Continue

1963 transmission dipstick tube came out

Started by Karl Schwarz in 1963/64 Cadillac Specific Discussion. Last reply by Kurt yesterday. 1 Reply

I went to check the fluid in the transmission on my 1963 Series 62 convertible and when I pulled on the dipstick ring the whole tube came out. I got it back in the hole, sort of, but it is loose.…Continue

Blog Posts

Frame Markings

Posted by Gene McIlroy on August 12, 2019 at 6:26pm 1 Comment

Just got my frame back from powder coating so thought I would post photos of the front and rear frame markings.…


Lining up the drive shaft

Posted by Dominic Salemi on August 12, 2019 at 5:47pm 2 Comments

Can anyone shed some light on how to position the complete drive shaft in the correct position? I want to make sure my drive shaft is installed properly.



Upper A Arm Rubber Bumpers

Posted by Gene McIlroy on August 12, 2019 at 1:30pm 3 Comments

I have found a very good replacement part for the Upper A Arm Bumpers.  The top part is identical to the originals the bottom can be used as is or after a few minutes with a belt sander can be ground to the V shape as the originals were.  The replacement bumpers are for a 2001 to 2005 S10 Sanoma or Blazer.  Part number is on the box in the photos.  First photo is the box next to the box is the S10 part and an original.  Next photo shows my sanded down part next to an original.…


Roof motor

Posted by Dermot Robinson on August 11, 2019 at 8:44am 2 Comments

Replacing my convertible roof motor.

Has anyone any experience or advice on replacing the roof motor on a 1964 Cadillac Deville .



  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service