I have decided to sell my 1963 convertible. frame off restoration completed in may 2019, driven under 500 miles since. appraised at 60000 Canadian(45000 US) asking price $49,900 Canadian (38000) US. the car has the following options,  airconditioning, cruise control, tilt steering, am/fm radio, guidematic headlamp dimmer, trunk release and pulldown, power windows, power seat, power top, front and rear seat belts and posi controlled differential. painted gm standard red in base coat clear coat, all stainless polished, chrome replated except cluster bezel, interior done in correct pattern red leather with crest embossed in frt and rear seats  ,rebuilt engine, trans, suspension and brake system. I would consider a 63 or 4 cadillac 4 door as partial trade,but must have ac. car is located in lethbridge alberta Canada. 403 331-9905

Views: 200

Attachments:

Reply to This

Replies to This Discussion


Maurice 

The 63 looks outstanding in the photos with outstanding  attention to detail ( so fine ) 

Good luck with the sale 

Do you also have— a 64 convertible in a torquoise color you are redoing ? 

Enjoy 

Love the attention to detail, especially in the engine compartment. This one make someone a fine 63 convertible!

sold

Congrats on the sale!

I do second - the Congratulations 

Very glad to see such a fine restoration being worthy of the detail that surely when into that one 

One Stunning 63 convertible going to a new very happy Classic Antique Cadillac Owner !!

You gonna miss the —- Attention ? ( maybe ?) 

Enjoy 

Thanks guys now the search is on for a nice driver quality 63-4 sedan deville, Fleetwood or 63 park ave.

RSS

Photos

  • Add Photos
  • View All

Forum

Bendix Power Brake Unit Power Section

Started by Mathis Richter in 1963/64 Cadillac Specific Discussion. Last reply by Chris Codd 7 hours ago. 7 Replies

Hi,I have a huge problem my POWER SECTION of the ``Master-VAC Power Brake unit 9´´Diameter ´´ from Bendix is Broken and I can't open it to replace al the rubber parts did some of you have auch Power…Continue

Third brake light -help please.

Started by paul k in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 14 hours ago. 8 Replies

Did anybody from the club install third brake light in the rear window in his Cadillac? I have problem to figure out how to do it. Can I just run wire from break pedal switch and second wire connect…Continue

Extra speakers in the cadillac.

Started by paul k in 1963/64 Cadillac Specific Discussion 14 hours ago. 0 Replies

Ok, I have another question. Since I will run wire for a brake light I might run speakers wires.I would like to install 2 extra speakers or maybe 4. What is best option. I do have 2 speakers already-…Continue

429 and 400 trans. for sale

Started by Mark C Bills in For Sale. Last reply by Tony and Ginny 429 yesterday. 6 Replies

I have an excellent running 429 with 400 trans.recently removed from my 64. It has electronic ignition, new water pump,new fan and clutch(not pictured),new fuel pump,Holley 650 vac. sec. carb. with…Continue

Blog Posts

1964 Cadillac Fleetwood sixty special / transmission dipstick needed

Posted by Pablo on September 20, 2020 at 9:57pm 1 Comment

How are you doing folks, I’m looking for a transmission dipstick, any info I will appreciated, thank you very much

1963 Cadillac hood driver side hinge

Posted by Steven on September 16, 2020 at 9:23am 1 Comment

Hello,

 Does anyone know were I can buy a 1963 Cadillac hood driver side hinge or is there any other hinge that would fit? 

Thanks

Steven

Bad Guage?

Posted by Karl Schwarz on August 26, 2020 at 3:08pm 6 Comments

So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It  it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…

Continue

Website

Posted by Fritz Seitz on August 11, 2020 at 2:35am 0 Comments

I have been working on a website-----www.fritzsautorepair.com-----

Does anyone have suggestions?

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service