I am gathering up some stuff to put away for the potential trip home in oct/nov from MT to MS in the 63 cdv.

i thought a fuel pump may be a good piece to have nearby,  Are the newer ones like you can get at rock auto reliable and do they fit as they should or are original pumps around and a better bet/   Jason or Russ?   

Thanks,, 

Views: 42

Reply to This

Replies to This Discussion

I have never had any issue with the original or new aftermarket or rebuilt original style, but have heard there have been issues with some of the newer or rebuilt ones. Russ reported he had seen where they had not staked the valves in place, causing them to come apart and stop pumping. I have found the best new aftermarket pump, which looks like the original style fuel pump is the Spectra Premium B1297MP fuel pump. For years I kept a stock of new ones but the supply run out. AutoZone lists them now for about $70 but when you go to check out they are out of stock. The other new fuel pump I have seen in the last few years has been the Airtex 6744 Fuel Pump. I have not experience with this fuel pump but believe it may be the one others have had issues with the valve not being staked.

For years there were new single uni-body pumps available at auto parts stores like the one seen on the right in picture below that did not come apart. I also had not issue with those. 
If you want good used from known running engines, I sell the original style like seen on the left for $40 and the unibody style like on the right for $20.  

 

I put a new Airtex pump on my 63, it worked well for 15k miles until the inlet valve fell out of the pump body. The valve was not staked in, just a press fit causing the failure. If you buy the Airtex pump, take the bottom cover off to see if the valve is just pressed in. If so, stake it with a punch so it won't fall out. 

ok, thanks for the information,,,helps me out making a decision

Spectra Premium SP1297MP Mechanical Fuel Pump for 85:86 USD.

Not sure if its the same B1297MP Jason suggest.

RSS

Photos

  • Add Photos
  • View All

Forum

What front springs to use to level car back out after an LS swap?

Started by Richard Biele in 1963/64 Cadillac Specific Discussion 1 hour ago. 0 Replies

I see other members have put LS engines into their cars. I am wondering what springs you put in afterwards. I cannot determine the height due to the car having a front end fire (how I ended up with…Continue

2020 Cadillac calendars.

Started by Russ Austin in General Discussion 4 hours ago. 0 Replies

I just got in the 2020 Classic Cadillac calendars.  12 months of 63-64…Continue

Henry Leland- founder of Cadillac and Lincoln

Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 15 hours ago. 2 Replies

Here's a good article about Henry Leland. I had heard bits & pieces of his story over the years but didn't know all these details.…Continue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge 16 hours ago. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Blog Posts

driveshaft help

Posted by wayne weaver on October 9, 2019 at 4:41pm 1 Comment

can anyone help me with a driveshaft ? I have a 1963 Cadillac 62 series 4dr with the hydro-matic trans. I need the male splined shaft on the front of the rear driveshaft section. the piece with the nut attached by clip.id be willing to buy a shaft if its not horribly priced.

Dash removal

Posted by Jake Mickley on October 9, 2019 at 12:06am 9 Comments

Hello everyone,

On a 63 CDV, if a guy wanted to remove the entire dash to get all the metal painted, and do some other things behind there, how would he go about doing that?  I checked here and the shop manual, but can't find a complete guide.

As always, and help or direction is appreciated.  Thanks!

--Jake

Introducing myself

Posted by Gary Marchand on October 7, 2019 at 9:32pm 8 Comments

Thanks for letting me join the club.  Picked up this ‘64 Coupe Deville a few months ago out of Beverly MA, the car has few stickers on it from various Cadillac clubs, didn’t know if anyone might recognize it from it’s “Glory days.” Everything seems pretty healthy except for the body and some very Mickey Mouse repairs, was wondering if anyone had any leads on…

Continue

Carter AFB carburetor question

Posted by Ray Schick on October 7, 2019 at 8:29pm 8 Comments

3655S carb, and a 3656S carb .I know the difference is one is for A/C and the other in for a non A/C car . Now the question is : can I use the carb bowl from the A/C car on the non A/C car ? They look the same set up next to each other

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service