spring cleaning time, replaced the fuel filter after a long spell, and now a leak from the top of the tank!

related?

easily a drop a second or more in volume.

I’m assuming its a corrupt hose, is it easy to get at with the rear on jack stands?

 Thanks!

Views: 79

Reply to This

Replies to This Discussion

You have a gas tank venting hose in front of the gas tank- just above the rear axel
Do be sure that piece of metal S shaped tubing and hose are in good condition

Not sure what leaking from the top means but leaking gas can get expensive real quick with our prices rising every few days in Florida USA
From 2.19 a gallon to 2.59 at present in about a week or so

Enjoy

From reading other posts I ‘m hoping its the vent hose.

leaks down the front of the tank from the top.

 Thanks!

The gas tank overflow tube may not be in its correct position
A gas smell when on an incline is an indication That tube is not in its correct position
The hose coupling there can be worn cracked and leaking
Remove that hose to inspect it as i could not see the rubber hose damage until i did that in my case
The hose looked good until examining it in front of my nose with it off the car In my case so just a heads up on that
Really liked doing that necessary repair to eliminate my sometimes gas smell in my own garage
Felt good to eliminate that problem
All gas related rubber hosing SB ethanol compatble these days to prevent rubber hose detereration from the gas We are using

Enjoy

Replace all three fuel line hoses. They are rotten if never changed before and or the ethanol in the fuel has done them in. Vent, return and fuel line. As Tony has stated. 

All the fuel lines go to the top of the gas tank on the passenger side of the tank
Removing the rear passenger tire and rim will have you looking at the fuel lines there
Good chance one or more of those rubber hoses are split and damaged from wear and age

SB an easy fix just replacing hoses using hose compatible with todays Ethanol fuel and some hose clamps
An easy fix to loosing expensive gas and a gas fuel smell

Enjoy

A project for tomorrow then

thanks, and I’ll photo and report

cheers

Yes vent line was run too tight (90 degree bends) hard as a rock and many cracks.
All replaced now!
Thanks! love this forum!
Will

RSS

Photos

  • Add Photos
  • View All

Forum

Is this possible or total BS?

Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 6 hours ago. 5 Replies

After changing tie rods, i tokk car into wheel n allignment shop. He said no problem.  He calls back about 45 minutes later and said they couldnt get between the tire and cowl, the guys head was too…Continue

Vacuum / Parking Brake / NSS Question

Started by Karl Schwarz in 1963/64 Cadillac Specific Discussion. Last reply by Karl Schwarz 7 hours ago. 2 Replies

I bought a 1963 Series 62 Convertible in July.It makes a hissing sound when in neutral, and sometimes when in drive (when the shift is more to the left that the right. I assume this related to a NSS…Continue

Tail pipe black stuff!

Started by Lambert Ross in 1963/64 Cadillac Specific Discussion. Last reply by Lambert Ross yesterday. 10 Replies

any ideas how to clear the ugly black stuff shooting out from my tailpipe? After a long layover, it really messes up the garage floor. I assume its carbon but am not sure how best to react to it.…Continue

Blog Posts

still need a driveshaft

Posted by wayne weaver on November 26, 2019 at 11:53am 0 Comments

well thank you UPS for losing the driveshaft that Russ Austin shipped me. 

however i still need a rear driveshaft section for my 63. mine has a vibration due to the bushing inside of it. its a shame because the ball and sockets in the cardian joints are perfect but it has a woble on the balancing machine. so .  still need the rear section. anyone have a good one ? is there driveshaft alternatives to use ? i am really considering an LS swap and since im fighting the driveshaft search…

Continue

63 guidematic issues

Posted by maurice lapoiinte on November 24, 2019 at 3:10pm 0 Comments

 So my 63 guide matic headlamps stay on low beam all the time. I have so far bypassed the system and everything works normal. I have been thru the trouble shooting in the manual but this is where the confusion begins.on my car when the power relay is powered I have low beam and when its not powered I have highbeam, this appears to be opposite what the diagnosis says should be correct.The wiring is all original and no wires have been mixed up.has anyone ever unplugged the 2 wire connector…

Continue

Another advantage of the Pertronix III

Posted by Doug Scarrow on November 23, 2019 at 11:12am 1 Comment

   Having tried both the II and III I can say the multispark feature of the III offers a smoother idle . It is also easier to install .Does not require removal of the distributor

Stuck at two red (dash) lights!

Posted by Jeff Kinzler on November 3, 2019 at 10:00pm 9 Comments

I hope someone can help solve these two electrical problems that appeared one after the other.

By way of background: The car, a '64 Eldorado has very limited use. It was at a restoration shop for 15 months until last January-  that supposedly did a bunch of wiring repairs including rebuilding the gas gauge that still hasn't worked properly, and the clock that hasn't worked, and re-soldering the broken wires in the drive door. All window and seat controls appear to be…

Continue

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service