Anyone know where to pick up a harmonic balancer for a 63’ with 390 motor? I have a strange vibration in Park when I hold the pedal at a steady rpm. I’m thinking that may be the issue

Views: 48

Reply to This

Replies to This Discussion

Why do you think it is the balancer causing the vibration ?
Was it ever replaced before that you know of ?

The engine balancer needs to be balanced with the crankshaft assembly so replacing it could have the same result you have now -- a vibration

Enjoy

Well...that’s good info...no I’ve never replaced it....any ideas of what it could be if that’s not what it is?

I have a good balancer with a repair sleeve included.

Shoot me an email with your zip code for a shipping quote.   russ85747@hotmail.com 

When was the tune brought up to spec with all new parts Last time ?

A good tune will be the very best thing to have the engine run smooth as is possible ( reduce vibration ) 

With that done you can look for the next possible solution 

grab the fan  blade and see if it moves front to back as your water pump bearing might be going bad 

Condition of motor and trans mounts ?

engines will move around more in there seat if they are out of tune or a plug is fouling for example due to lack of maintenance which is 6,000 miles for our year cars 

it is a very short interval compared to today car maintenance schedules 

Enjoy

RSS

Photos

  • Add Photos
  • View All

Forum

FUEL GAGE

Started by STEPHEN HORWATH in General Discussion. Last reply by Tony and Ginny 429 9 hours ago. 7 Replies

Hi just wondering if anyone else had a problem with their fuel gauge going up to full when key is turned to the on position or when the car is running.  it goes back to empty when key is in the off…Continue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge 22 hours ago. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Front Window Motor Installation Help Needed

Started by Roy in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 yesterday. 9 Replies

I have a bad window motor in the passenger side door.  I have removed the door panel and am at a complete loss as to where to start and what to do from here.  Does anyone have any step by step…Continue

Intake manifold leak

Started by Joe DiIaconi in 1963/64 Cadillac Specific Discussion. Last reply by Roland Moser yesterday. 35 Replies

Anyone install better quality intake manifold gaskets?

Blog Posts

Hood Insulation

Posted by Dominic Salemi on July 3, 2019 at 9:15pm 2 Comments

Can anyone give me some information on what to use to secure my hood insulation to the hood.

Thanks

Dominic

64 Hood Hinge Color?

Posted by Bob Schles on June 27, 2019 at 4:46pm 2 Comments

Can someone tell me what color the hood hinges should be? I've seen both silver and gold cadmium plating colors on the cars. Thanks

Rear Side Window Stainless Sill Removal

Posted by Lee Martin on June 24, 2019 at 3:07pm 2 Comments

I'm looking to replace a piece of the stainless trim that sits on the outside of the car like a sill outside the rear passenger side window.  I can just barely see one screw at one end but does the door panel and/or window need to come out to access this?  If anyone has done this I'd like to learn what is involved.  Here's a photo of the piece I'm talking about:…

Continue

Cadillac Returns to its Roots Under New Leadership

Posted by Jeff Kinzler on May 1, 2019 at 12:30am 3 Comments

Cadillac’s new boss says they should stop trying to build BMWs and go back to building Cadillacs again.

What do you think? 

https://carbuzz.com/news/cadillac-finally-admits-what-everyone-knew-for-years

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service