more electrical issues

when I mounted the headlights, both low beams lights worked

the high beams did not

i replaced the pax side high beam and at that point, the low beams and the pax high beam worked, drivers high beam did not

i checked drivers high beam continuity and it failed. I replaced the drivers side high beam

now with low beams on, only the pax side works

with high beam selected, the high beams both work and the drivers side low beam work

the pax side low beam does not 

could this be a light issue? 

Tired of chasing my tail on these.....

HELP!

Views: 97

Reply to This

Replies to This Discussion

My headlight issues turned out to be caused by an internally corroded high beam switch. After taking the switch apart and cleaning it everything was working properly again.

My switch was working fine prior

i doubt it is a ground as the high beams wouldn’t work either

Before you chase wiring I would check each light bulb individually with a 12 volt source.  If I am reading your post correctly, then if the RH passenger Lo Beam coincidentally burned out, it would give you this symptom?  Always check the bulbs 1st.
Also, the outer headlights are Hi & Lo Beam double filament bulbs, so make sure you are testing both the Lo beam and Hi beam filaments.  There are 3 male tabs so you have to alternate between the 3 tabs to test Hi and Lo Beam.

If lights are flickering then I would suggest checking the black ground wire of the forward lamp harness just forward of the radiator core support, but this sounds like either burnt bulb filament(s), bad connection, or wiring... but since RH lo beam was working I would look at burnt filament or bad connection 1st. 

Thx again for all the suggestions

apparently, the 63 Cadillac is a bit temperamental WRT battery strength

my power seats were not moving......the motor was on, and I heard clicking.....and he headlights were acting up.

i replaced one low beam bulb and had the battery tested.....it failed.

i put the new battery in and presto......power seat is moving fwd and aft, and it tilts ......I still heard clicking, but will check this out later.

the new headlight works great...am replacing the other tomorrow

have a great weekent

RSS

Photos

  • Add Photos
  • View All

Forum

Classic Cadillac Parts For Sale - Misc Items

Started by Jason Edge in For Sale. Last reply by Jason Edge 5 hours ago. 165 Replies

I have posted a few Misc items over on my Classic Cadillac Parts Facebook page at…Continue

Tags: classic cadillac parts, classiccadillacparts

Looking for 64 to 66 seat belt buckles, male and female together.

Started by Ryan Frawley in Wanted to Buy. Last reply by Tony and Ginny 429 yesterday. 5 Replies

Hey all, I am in the process of finishing up my 64 coupe deville and noticed that the front seat belts only have the retractor side in the bag I put all the belts in when I got it. I have found it…Continue

Tags: buckle, safety belt, seatbelt, seatbelts

Movie Star Cars.

Started by Kevin Campbell in General Discussion. Last reply by Kurt yesterday. 17 Replies

We have the Village Roadshow film studios about an 1.5 hour drive away.They've put out a call for cars to appear in a movie about Elvis. :-)So, I nominated our 64 Fleetwood as a potential "Movie Star…Continue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge yesterday. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Blog Posts

Stuck at two red (dash) lights!

Posted by Jeff Kinzler on November 3, 2019 at 10:00pm 9 Comments

I hope someone can help solve these two electrical problems that appeared one after the other.

By way of background: The car, a '64 Eldorado has very limited use. It was at a restoration shop for 15 months until last January-  that supposedly did a bunch of wiring repairs including rebuilding the gas gauge that still hasn't worked properly, and the clock that hasn't worked, and re-soldering the broken wires in the drive door. All window and seat controls appear to be…

Continue

driveshaft help

Posted by wayne weaver on October 9, 2019 at 4:41pm 1 Comment

can anyone help me with a driveshaft ? I have a 1963 Cadillac 62 series 4dr with the hydro-matic trans. I need the male splined shaft on the front of the rear driveshaft section. the piece with the nut attached by clip.id be willing to buy a shaft if its not horribly priced.

Dash removal

Posted by Jake Mickley on October 9, 2019 at 12:06am 9 Comments

Hello everyone,

On a 63 CDV, if a guy wanted to remove the entire dash to get all the metal painted, and do some other things behind there, how would he go about doing that?  I checked here and the shop manual, but can't find a complete guide.

As always, and help or direction is appreciated.  Thanks!

--Jake

Introducing myself

Posted by Gary Marchand on October 7, 2019 at 9:32pm 8 Comments

Thanks for letting me join the club.  Picked up this ‘64 Coupe Deville a few months ago out of Beverly MA, the car has few stickers on it from various Cadillac clubs, didn’t know if anyone might recognize it from it’s “Glory days.” Everything seems pretty healthy except for the body and some very Mickey Mouse repairs, was wondering if anyone had any leads on…

Continue

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service