When I did the 3 drive belts up the front, I just couldn't help myself. At least it looked good until I started it.

And just a couple of shots after I did the A/C fan motor repair. (Still going good too)

If you're wondering about the top rad hose, its a Nissan Urvan bottom rad house cut and shut to fit with a sleeve. By painting the sleeve black and using black heat shrink on the hose clamps, it sort of blends in ok, well, ya might have to squint a little bit huh.

Hard to get the correct hose in land Down Under.... But there is always a second way to do everything.

Views: 115

Reply to This

Replies to This Discussion

Done, Just tick the 'center' option as you post them. If you leave them 'full' they will stretch.

Just replied with the 3 shipping options.

Well, some repair their cars with bicycle parts and some with Japanese hoses...   ;-)

RSS

Photos

  • Add Photos
  • View All

Forum

Wanted: retaining clips for dash pad legs

Started by Mark Geertsma in Wanted to Buy. Last reply by Russ Austin 6 hours ago. 1 Reply

Looking for the retaining clips (L+R) that the "legs" of the dashpad snap into. Mine are missing. Continue

1964 429 & Trans For Sale

Started by Russ in For Sale 14 hours ago. 0 Replies

Anyone in need of a 429 & trans? Was running when pulled from car but had low compression on a few cylinders if memory serves me right. Engine/trans are in Phoenix. Russ, 562.858.6926Continue

Center bearing - replacement.

Started by Anders in Restoration Discussion. Last reply by Norman Silverman 17 hours ago. 22 Replies

Had some sound from the propeller shaft and as the rear wheel bearings just been replaced I thought it would be the center bearing. Removed the propeller shaft and checked the center bearing (as per…Continue

1964 coupe de ville trunk v emblem

Started by ANGELO MARTINEZ in Restoration Discussion. Last reply by James jacques 23 hours ago. 1 Reply

hello I am looking for the v emblem on a 1964 coupe de ville trunk  v emblemthank youContinue

Blog Posts

64 Recirc/Fresh Air Door Actuator replaced; FROM THE INSIDE.

Posted by Norman Silverman on February 4, 2019 at 11:21pm 8 Comments

I am happy to report that I have successfully replaced the Fresh Air/Recirc door actuator that is located on the blower box-and have done so without having to remove the blower box. I did it by taking out the glove box and attacking it from the back.  It took several days, LOTS of patience and some band-aids, but it is done. THE most difficult part -BY FAR- is to remove and then replace the screw that sits on the actuator arm, connecting it to the fresh…

Continue

Flashers

Posted by Mike Petrey on January 13, 2019 at 12:25pm 7 Comments

Where do the flashers go in my 64 Deville Convert.  I'm thinking that's why both turn signals stopped working.

Source for Motor mounts and Trans mounts 1964 SDV

Posted by Norman Silverman on January 9, 2019 at 4:23pm 4 Comments

Hi.

Where is the best place to purchase good quality motor mounts/trans mounts for my 1964 SDV? I see that Rock Auto has them for $8 and change, and others for $24 and change. Big difference. Is there a better place to buy them from?

Thanks

Norm

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service