Looking for a non- tilt turn Signal Switch and harness for 63 Cadillac De Ville

Views: 101

Reply to This

Replies to This Discussion

Is that your switch in the picture?

No , mine is still in the car but I have been told that this is what I need.

If you would like some tips on removing the steering wheel and getting to that switch in a non tilt steering column
Go to the search engine at the top right of the home page
Put in : steering wheel removal
It's a tread i wrote about the subject when i repaired my cornering lights
The green wire was broken on mine after i determined i had to go into the column from other electrical testing Done

Enjoy

Thanks mate I might have the same or similar problem appreciate the advice 

What are the symptom's of the switch?  These are not being reproduced and it may just need a cleaning.

Hi Anthony,

I have one of these switches. Send me an e-mail: faresmcmthelix@msn.com.

Charles Fares

La Mesa, California

RSS

Photos

  • Add Photos
  • View All

Forum

Center bearing - replacement.

Started by Anders in Restoration Discussion. Last reply by Norman Silverman 7 hours ago. 23 Replies

Had some sound from the propeller shaft and as the rear wheel bearings just been replaced I thought it would be the center bearing. Removed the propeller shaft and checked the center bearing (as per…Continue

The Central Florida weather could just not get any better !!

Started by Tony and Ginny 429 in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 8 hours ago. 1 Reply

No Description

Wanted: retaining clips for dash pad legs

Started by Mark Geertsma in Wanted to Buy. Last reply by Russ Austin 15 hours ago. 1 Reply

Looking for the retaining clips (L+R) that the "legs" of the dashpad snap into. Mine are missing. Continue

1964 429 & Trans For Sale

Started by Russ in For Sale 23 hours ago. 0 Replies

Anyone in need of a 429 & trans? Was running when pulled from car but had low compression on a few cylinders if memory serves me right. Engine/trans are in Phoenix. Russ, 562.858.6926Continue

Blog Posts

64 Recirc/Fresh Air Door Actuator replaced; FROM THE INSIDE.

Posted by Norman Silverman on February 4, 2019 at 11:21pm 8 Comments

I am happy to report that I have successfully replaced the Fresh Air/Recirc door actuator that is located on the blower box-and have done so without having to remove the blower box. I did it by taking out the glove box and attacking it from the back.  It took several days, LOTS of patience and some band-aids, but it is done. THE most difficult part -BY FAR- is to remove and then replace the screw that sits on the actuator arm, connecting it to the fresh…

Continue

Flashers

Posted by Mike Petrey on January 13, 2019 at 12:25pm 7 Comments

Where do the flashers go in my 64 Deville Convert.  I'm thinking that's why both turn signals stopped working.

Source for Motor mounts and Trans mounts 1964 SDV

Posted by Norman Silverman on January 9, 2019 at 4:23pm 4 Comments

Hi.

Where is the best place to purchase good quality motor mounts/trans mounts for my 1964 SDV? I see that Rock Auto has them for $8 and change, and others for $24 and change. Big difference. Is there a better place to buy them from?

Thanks

Norm

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service