Has anyone found a good kit to replace all of the bushings including ball joints,  tie rod inner and outer, upper and lower control arm bushings, center link. I replace mine a couple years ago, but as I've been told new to you does not make it new. Looking for an American-made product of high quality.

Views: 45

Reply to This

Replies to This Discussion

Joe D
You can try Kanter located in NJ to see if they have what you need

Enjoy

Thank you Tony 

Moogsuspensionparts.com

RSS

Photos

  • Add Photos
  • View All

Forum

WTB: 390 non AC 2 groove crank & water pump pulleys

Started by Ian Osborne in Wanted to Buy 57 minutes ago. 0 Replies

I'm looking for a pair of 2 groove engine pulleys for a '63 390. Appearance not important so long as they are straight and can be repainted.Continue

Light drama

Started by Jake Mickley in 1963/64 Cadillac Specific Discussion. Last reply by Jake Mickley 2 hours ago. 16 Replies

Hello everyone. It's been a while since I posted here and I hope all is well with everyone and they had a good winter. I can't remember who it is but I know there's an Australian in here too, so I…Continue

Turning a 390 into a 429

Started by Jeroen Welgemoed in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 4 hours ago. 3 Replies

Hi everyone!My name is Jeroen and i have a 1964 cadillac sedan deville 6 window. That i am currently rebuilding. I already got a lot of information of you guys just by reading some discussions.…Continue

CLC 2018 Grand National - San Marcos, Texas, June 5-9

Started by Jason Edge in General Discussion. Last reply by Jason Edge 5 hours ago. 13 Replies

Host Hotel:  Embassy Suites by…Continue

Tags: Marcos, Texas, San, National, 2018

Blog Posts

Need correct Muffler for 64 DeVille

Posted by Norman Silverman on June 18, 2018 at 7:57pm 10 Comments

Hello all.

I need to replace the muffler on my 64 and the local shop does not have the correct one.

After looking on the web site's help section, I still don't see a recommended part/manufacturer or suggestion. 

What is the best solution to purchase for a stock, single system with 2 1/2 inch pipes, center in, offset out? 

Thanks.

Norm

64 Power Seat Transmission cleaning-it did the trick

Posted by Norman Silverman on June 16, 2018 at 5:36pm 4 Comments

Hello All.

I thought I'd post a little encouragement for those that might have an inoperative 6 way power seat in their car. The fix is relatively easy, and VERY cheap.

I just purchased an original (not re-painted, nor reupholstered) 64 Sedan De Ville 4 window. When I purchased it the front seat was adjusted forward and tilted down in front; two of the worst positions for me, so I had no choice but to attempt to repair it. 

Pushing the switch in each direction brought…

Continue

Driver side door panel removal

Posted by Anthony Boles on June 16, 2018 at 9:32am 2 Comments

How is the door panel taken off to access the wiring harness 

Driver side door panel removal

Posted by Anthony Boles on June 16, 2018 at 8:16am 0 Comments

How is the door panel taken off to access the wiring harness 

Videos

  • Add Videos
  • View All

© 2018   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service