I looked into getting a new rubber boot for the drivers side door jamb wires. It will cost around 225.00 each. These are going to look as close to the original part as possible, but I see the cost as a problem. Not many people want to spend that.
This would fit the 63/64.
Way to much money for that item i do believe
Have you checked on just having the "tit" rivets made for the boots. I have ordered several different glove box bumpers but none of them have the groove thickness to match the double rubber thickness, I would think that there might be a market for just a set of new rubber rivets. I always thought that the "tits" were molded into the bottom half of the boot, They actually just sew both halves together.
Just a thought,
I did some looking and found a good piece to use. Only problem is I have to order 4000
Wow, that's a bunch, Do you remember what the part and part number was that you found?
3D printing will most likely save our cars.
I have very good sedan rears for $20 each or $35 for a LH and RH set. Shipping would be $7 to US destinations. If interested shoot me an email to email@example.com
The project is dead due to the costs involved.