I looked into getting a new rubber boot for the drivers side door jamb wires.  It will cost around 225.00 each. These are going to look as close to the original part as possible, but I see the cost as a problem. Not many people want to spend that. 

This would fit the  63/64.

Views: 238

Reply to This

Replies to This Discussion

Way to much money for that item i do believe

Enjoy

Russ

Have you checked on just having the "tit" rivets made for the boots.  I have ordered several different glove box bumpers but none of them have the groove thickness to match the double rubber thickness,  I would think that there might be a market for just a set of new rubber rivets.  I always thought that the "tits" were molded into the bottom half of the boot,  They actually just sew both halves together.

Just a thought,

I did some looking and found a good piece to use. Only problem is I have to order 4000

Wow, that's a bunch,  Do you remember what the part and part number was that you found?

3D printing will most likely save our cars. 

I did clean mine front pair and I want to find rear ones.

Rear ones are very  bad.

I have very good sedan rears for $20 each or $35 for a LH and RH set. Shipping would be $7 to US destinations. If interested shoot me an email to jasonedge@nc.rr.com

Any update on this? Ive been debating trying to make my own.

The project is dead due to the costs involved.

RSS

Photos

  • Add Photos
  • View All

Forum

Turn signal switch needed

Started by Roy in 1963/64 Cadillac Specific Discussion. Last reply by John Aguilar 19 hours ago. 5 Replies

Looking for a turn signal switch for my '64 coupe DeVille. The mechanic working on it said it's the cause of the passenger rear blinker and brake light not working. This is a big issue since police…Continue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by douglas krathwohl yesterday. 1 Reply

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Caddy Bling

Started by Joe DiIaconi in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 yesterday. 8 Replies

Continue

1964 left hand (drivers side) headlight door lower trim (boomarang) needed

Started by Michael Francioni in Wanted to Buy yesterday. 0 Replies

Must be in good condition for show car or open to a good donor for rechoming but must be pit free. send info to sanremo120@msn.com along with pictures. Thanks...…...Continue

Blog Posts

1964 Cadillac Fleetwood sixty special / transmission dipstick needed

Posted by Pablo on September 20, 2020 at 9:57pm 1 Comment

How are you doing folks, I’m looking for a transmission dipstick, any info I will appreciated, thank you very much

1963 Cadillac hood driver side hinge

Posted by Steven on September 16, 2020 at 9:23am 1 Comment

Hello,

 Does anyone know were I can buy a 1963 Cadillac hood driver side hinge or is there any other hinge that would fit? 

Thanks

Steven

Bad Guage?

Posted by Karl Schwarz on August 26, 2020 at 3:08pm 5 Comments

So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It  it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…

Continue

Website

Posted by Fritz Seitz on August 11, 2020 at 2:35am 0 Comments

I have been working on a website-----www.fritzsautorepair.com-----

Does anyone have suggestions?

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service