I looked into getting a new rubber boot for the drivers side door jamb wires.  It will cost around 225.00 each. These are going to look as close to the original part as possible, but I see the cost as a problem. Not many people want to spend that. 

This would fit the  63/64.

Views: 139

Reply to This

Replies to This Discussion

Way to much money for that item i do believe

Enjoy

Russ

Have you checked on just having the "tit" rivets made for the boots.  I have ordered several different glove box bumpers but none of them have the groove thickness to match the double rubber thickness,  I would think that there might be a market for just a set of new rubber rivets.  I always thought that the "tits" were molded into the bottom half of the boot,  They actually just sew both halves together.

Just a thought,

I did some looking and found a good piece to use. Only problem is I have to order 4000

Wow, that's a bunch,  Do you remember what the part and part number was that you found?

3D printing will most likely save our cars. 

I did clean mine front pair and I want to find rear ones.

Rear ones are very  bad.

I have very good sedan rears for $20 each or $35 for a LH and RH set. Shipping would be $7 to US destinations. If interested shoot me an email to jasonedge@nc.rr.com

Any update on this? Ive been debating trying to make my own.

The project is dead due to the costs involved.

RSS

Photos

  • Add Photos
  • View All

Forum

Extension Housing Hydramatic

Started by M123 in 1963/64 Cadillac Specific Discussion. Last reply by M123 1 hour ago. 1 Reply

Hi.Can you on a 64 remove the extension housing with the gearbox still in the car? The car have the Hydramatic.Did work on the car last night and did feel a very large play on the outgoing axle,…Continue

1965 Cadillac DeVille

Started by DanielAndrew in For Sale yesterday. 0 Replies

1965 Cadillac DeVille On Ebayhttps://ebay.to/2W6axyTContinue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Kurt yesterday. 2 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Trun signal swit

Started by Jeff S. in Wanted to Buy. Last reply by Charles Fares yesterday. 2 Replies

Hello all!Looking to either repair my existing turn signal switch or source a new one. Any suggestions?Thank you ub advance!Continue

Blog Posts

Cadillac Returns to its Roots Under New Leadership

Posted by Jeff Kinzler on May 1, 2019 at 12:30am 3 Comments

Cadillac’s new boss says they should stop trying to build BMWs and go back to building Cadillacs again.

What do you think? 

https://carbuzz.com/news/cadillac-finally-admits-what-everyone-knew-for-years

Radiator And Shrouds

Posted by Dominic Salemi on April 24, 2019 at 3:36pm 1 Comment

Hello

Anyone have a decent radiator and shrouds and hardware for a 1964 Cadillac deville. I have an alum. radiator and I'm deciding on to fix it or back to the original one. If I fix it I won't need parts.

Thanks

64 Recirc/Fresh Air Door Actuator replaced; FROM THE INSIDE.

Posted by Norman Silverman on February 4, 2019 at 11:21pm 8 Comments

I am happy to report that I have successfully replaced the Fresh Air/Recirc door actuator that is located on the blower box-and have done so without having to remove the blower box. I did it by taking out the glove box and attacking it from the back.  It took several days, LOTS of patience and some band-aids, but it is done. THE most difficult part -BY FAR- is to remove and then replace the screw that sits on the actuator arm, connecting it to the fresh…

Continue

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service