Well, i think  i have the  oil pump cover gasket back on and not leaking,, at least i took it for a short ride, and no apparent hemorrhage,, will go give it a feel and see if any thing is on the bottom of the seams.

my newest notice of things, was after my ride, i can hear the radiator bubbling under the cap.  Car isn't over heating,, staying at the 1/4 mark.  i havent ever noticed it before.  In addition to that, it seems to be coming out of the overflow hose.  When i bought the car, i never did see an over flow tank, and dont remember seeing a picture with one on there, so is there one supposed to be on there?  i have checked the hoses, dont  see any leaking or anything.. 

anyway, thoughts on what causes the radiator to be bubbling,  

Views: 263

Reply to This

Replies to This Discussion

I rented the unit,,, did a manual test,, pumped it to 13,,,, first time,, leaked out of three hoses.. and feel accordingly,

tightened up the hoses again, and pumped back to 13,, it held right there for about 10 to 15 minutes,, would that indicate i am ok on the HG leaks or do i need to do the engine on test as well.

Sincerely

well, i did the warm engine test as well.. pu the cap on, tightened it down.  turn on the engine. and waited,, it got up to temp  1/4 on the meter.  where it usually runs at.  

the pressure gauge got up to and stayed at about 7 to 8 psi.  and pretty much stayed there,, no jumping, ups or downs, just stayed there.  so i figured that was stable, as much as i know about it,,  anyway, i shut it down,, and it climbed to about 9 to 10 as it cooled down,  never got up to the 13 range.  sat at the turned off a pressure, for a while and then started to come on down slowly.

SO i am hoping that these two test leave out the possibility of HG leak,,, i may change oil one more time, to get what was left from the last change, to make sure that all the color dye is over.  

does it sound like this is where the car needs to be as far as cooling given the two test?  

Looks like all is good
Good you found the hose leaks

Enjoy

Sounds like you are ready to drive the car with confidence. Change the oil again, it could not hurt to do so. 

This just goes to show that correct troubleshooting goes along way in finding and fixing a problem.   For the rad overflow, you could just safety wire an old coke bottle to the bottom of the radiator core support, and run a hose to that.

I took the small bottle from The window washer that sits behind grill on driver side,  wired it to shroud,  works ok.  I did drop my coolant to exactly one inch below lip of rad opening.  Still get a little blow i. The bottle but not quite as much when it was higher

When you have an overflow bottle you can fill the rad to the top.

Ok.  this is long w pictures..Still some concerns about oil color.  I last changed oil 10 days ago.  Because i noted a green tint after shop visit and his diclosure of dye to find a leak.  Then. I broyght up subject here about radiator overflow.  Which i think due to overfill, was going out of hose. So i installed water bottle, lowered fluid level to one knuckle from bottom of fill neck. (1 inch).  After sveral drives, i have about a tablespoon in overflow.

Well, i took off oil filter to. Access the neck after my oil pump gasker cover had a very small drip, so had to get bk to the neck after replacement to prime. So. I noted that deep green color in the filter. Got the pressre tester, tested manually to 13 lbs,  hoses gave, retightened, presure held at 13 for at least 10 minutes. It had slipped to like one half the width of the needle after about 15 min.  

Also did warm up test, results were held 7 to 8 lbs, no bounceing around, just steady for ten or so min.  Shut off car. Pressure rose to 9 or 10, then slowly backed off as engine cooled.  So, i thought everything ok. I have not lost ANY coolant, every morning i check, hits knuckle at same place.  So, still concerned about oil and AF mix, decided to drain oil again.  Sampled it immediately after scree came out and midway to see if settled content would be different.  Got the green stuff consistently.  

So i lgot curious,  what does oil an AF do when you mix.  Poured a half and half,  gave it a good stir and shake.  It mixed lots of bubbles and DEFINITE separation before the shake and stir.  But after about 10 minutes, it separated to two distinct fluid colors,  looking nothing like the stuff i had come out of pan.  The mixture from the pan,  after two hours is showing NO sign of separation. But jist dark green

None of my stuff looks lije the milky stuff from head gasket leak picutures,  i am not over heating, at all,  i hv never gone over a needle width past 1/4 on tge gauge.  I am not leaking AF or showing any sign of it going down.  I read the manual, checked head bolts,  seem very tight.  Based on all of above, w pictures, descriptions,   should i be concerned w the greenish oil and AF.  I just dnt want an HG leak and dmg the engine.

Pic 1. Oil

Pic 2 oil from car

Pic3 oil and AF after settling from shake and stir and oil from car after couple hours sitting.  No signs of settle


Kim
The seperation seems to be water and coolant on the bottom and oil on the top
Oil floats on water
Not sure the cause

If you are going to use abreviations please write it out the first time you use it in a post so it can be understood thru the rest of the post --thanks
Not sure what AG and HG mean here so hard for me to understand the post

Did you change the oil filter with the last oil change or you left a quart of the dyed oil in the engine that may be what you are looking at

Enjoy

Coolant is the bottom, yes.

Yes, changed oil filter.  

Hg  = head gasket

Af.  = Antifreeze.   It would seem the oil from the car would begin at some point to separate, but it doesnt.  Maybe because it has been subjected to heat,  i dnt know.  Just concerned with the color change and if its AF

I think you are using Amsoil -- so these oil changes do not come cheep --for sure

Where exactly did the glass with the fliud seperation come out of ?

Enjoy

Because i knew i was going to change fluud in a week or so, i went with the standard  high mileage synthtic until i knew problem solved.

One container is a drinking glass, other a candle holder.  Both were clean before putting fluid i. Them.  Oil was cold at extraction from engine

Where did you remove the oil from the engine in each glass ?

Enjoy

RSS

Photos

  • Add Photos
  • View All

Forum

different exh

Started by Russ Austin in General Discussion. Last reply by Tony and Ginny 429 3 hours ago. 6 Replies

Parts car #16 has a different exh setup.  Has anyone run a set up like this before?  I see an advantage of keeping the muffler heat off of the driver floor.…Continue

63/64 Body construction quality.

Started by Chris in General Discussion. Last reply by Chris 4 hours ago. 3 Replies

Hey guys I was just curious to know what everyone thought about the quality of the sheet metal, the frame and the overall stoutness of our cars vs other makes and models of the day?One thing I can…Continue

Radiator coolant

Started by Warwick smith in 1963/64 Cadillac Specific Discussion. Last reply by Anders yesterday. 1 Reply

hiwhat type of radiator coolant do most of you use for a 63 with air con Continue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge yesterday. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Blog Posts

where do I find a new and better motor?

Posted by john kilbourne on May 24, 2018 at 11:43am 9 Comments

My '64 convert is getting better, but the engine remains questionable. Starts and runs well enough, powerful, but I think I hear a main bearing banging, the balance is not great and I'd like to upgrade to fuel injection if I can.

Are there dependable remans available of good quality? Are new crate engines available? Will more advanced engines from newer years fit?

Also, please, the diff ratio is quite high, lots of RPMs compared to today's cars. Are there diffs with lower…

Continue

1963 Cadillac DeVille

Posted by Sven on May 21, 2018 at 8:00am 0 Comments

Good morning community, I have this beautiful 1963 4 door for sale, asking cad$9999, that's about us$7750. I would bring it down south over the border to North Dakota or Minnesota.

If anyone is interested, feel free to ask questions.

Otherwise what are the best websites to sell classic cars in the states?



Please view this ad:



63 cadillac deville ,…

Continue

camshaft

Posted by Dave Fundaburg on May 20, 2018 at 11:49am 1 Comment

Has anyone used the performance camshafts offered by Kanter or Isky if so how do you like the upgrade in general and how is the idle quality and vacuum for power accessories any advice would be greatly appreciated, thanks.

Door jamb switchs

Posted by Anthony Boles on May 17, 2018 at 9:50am 10 Comments

I'm having problems with the door jamb switches,the interior lights will sometimes work or the interior lights will just stay on and run the battery down ,there's three black wires spliced together and one simgle black and white wire,what could be the problem. 

Videos

  • Add Videos
  • View All

© 2018   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service