got house built i have been slaving over for last 5 months,, now have time to work on the 63.

I just ordered some rubber parts for window rail, rear window pillar, and the window and out,

are there any other additional pieces i need to order, like clips or the like.  and is there any particular method to use or will the manual explain the removal process.


Views: 53

Reply to This

Replies to This Discussion

If you are removing the door glass, just take the 2 screws out that hold the roller bar to the window frame. The glass and frame will lift right up once you take the 2 screws out and remove the roller bar from the frame.

I was alos referring to the rubber strip that attached to the top,were the top o the window seals against the body, and the front of the door frame fits agains the front window pillar.. 

are those pulled out and then reapplied with an adhesive or are there screws on pins or clips on the underside that have to be removed and replaced...

The top roof line seal is held in place by the lips of the trim. I have used adhesive before. First time you install it, don't use adhesive, so you cab check the fit.

ok,  thanks

i ordered the felts, etc from rtrw,  and i just got through reading a long string on the suspension and rtrw and steeled etc,, was all that about the parts being inferior or one being the middle man for the other for suspension parts or does it apply to all there parts,,,,,, just curious as when i orders, i never got a response from rtrw, so i checked on the order and they said all th parts had to be ordered,,  


just a possible issue with rear control arm bushings not other products they sell 




  • Add Photos
  • View All


Comfort Control and voltage from the voltage regulator or alternator

Started by Christian Doerk in 1963/64 Cadillac Specific Discussion 3 hours ago. 0 Replies

I probably currently have a similar problem like Sam G in this post:…Continue

Tags: alternator, transducer, regulator, voltage, Control

courtesy light wiring

Started by Andy Kalnins in 1963/64 Cadillac Specific Discussion. Last reply by Mark S Anderson yesterday. 16 Replies

My right rear door courtesy light has two wires- a solid red and a black w/ white stripe. What puzzles me is that both wires have voltage across them when the key is turned to the left or right. To…Continue

Tags: wiring, light, courtesy

CLC 2019 Grand National - Louisville, Kentucky, June 11-15, 2019

Started by Jason Edge in General Discussion. Last reply by Tony and Ginny 429 yesterday. 27 Replies

1963/64 Cadillac Chapter 2019 Grand National Page…Continue

Tags: National, Grand, CLC, 2019

1979 Cadillac DeVille Phaeton Diesel

Started by DanielAndrew in For Sale yesterday. 0 Replies

1979 Cadillac DeVille Phaeton Diesel On Ebay…Continue

Blog Posts

Cadillac Returns to its Roots Under New Leadership

Posted by Jeff Kinzler on May 1, 2019 at 12:30am 3 Comments

Cadillac’s new boss says they should stop trying to build BMWs and go back to building Cadillacs again.

What do you think?

Radiator And Shrouds

Posted by Dominic Salemi on April 24, 2019 at 3:36pm 1 Comment


Anyone have a decent radiator and shrouds and hardware for a 1964 Cadillac deville. I have an alum. radiator and I'm deciding on to fix it or back to the original one. If I fix it I won't need parts.


64 Recirc/Fresh Air Door Actuator replaced; FROM THE INSIDE.

Posted by Norman Silverman on February 4, 2019 at 11:21pm 8 Comments

I am happy to report that I have successfully replaced the Fresh Air/Recirc door actuator that is located on the blower box-and have done so without having to remove the blower box. I did it by taking out the glove box and attacking it from the back.  It took several days, LOTS of patience and some band-aids, but it is done. THE most difficult part -BY FAR- is to remove and then replace the screw that sits on the actuator arm, connecting it to the fresh…




  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service