I try to scrutinize anyone trying to sign up to the 63/64 site pretty closely, but sometimes people get thru. Someone named James Pollard got thru and posted on some of your personal pages on the site. This person has been removed.  So if you saw something earlier, you can ignore as the person has been removed. If you suspect a spammer email me at jasonedge@nc.rr.com and will zap them from the site. I probably get 20+ requests a week to join from these spammers and usually catch them but if they tick off all the check boxes and have valid answers to the sign-up questions they usually are approved. I did do an IP address look-up for "James Pollard" and it matched the California address giving. 

Views: 54

Reply to This

Replies to This Discussion

Was that the post that had the chick with boobs and legs revealed a fair bit.

It was about 2 weeks ago.

Wait, what? How did I miss the chick with boobs and legs? Dangit let him back in here!!!!

No, it was earlier today. Sorry you guys missed it. I'll be sure to send all the pervs and miscontents to Kev and Clovis going forward! 

Seems only fair to me.... what about you Clovis?

Please send all spammers to Kevin!!!!

I am getting 10-20 emails every day with fraud attempts. Hate it every time. Never replies to any just deleting it. But its a burden and the internet (whoever that is) should stop it.

I'm in Kev 

RSS

Photos

  • Add Photos
  • View All

Forum

Wanted: retaining clips for dash pad legs

Started by Mark Geertsma in Wanted to Buy. Last reply by Russ Austin 6 hours ago. 1 Reply

Looking for the retaining clips (L+R) that the "legs" of the dashpad snap into. Mine are missing. Continue

1964 429 & Trans For Sale

Started by Russ in For Sale 14 hours ago. 0 Replies

Anyone in need of a 429 & trans? Was running when pulled from car but had low compression on a few cylinders if memory serves me right. Engine/trans are in Phoenix. Russ, 562.858.6926Continue

Center bearing - replacement.

Started by Anders in Restoration Discussion. Last reply by Norman Silverman 18 hours ago. 22 Replies

Had some sound from the propeller shaft and as the rear wheel bearings just been replaced I thought it would be the center bearing. Removed the propeller shaft and checked the center bearing (as per…Continue

Blog Posts

64 Recirc/Fresh Air Door Actuator replaced; FROM THE INSIDE.

Posted by Norman Silverman on February 4, 2019 at 11:21pm 8 Comments

I am happy to report that I have successfully replaced the Fresh Air/Recirc door actuator that is located on the blower box-and have done so without having to remove the blower box. I did it by taking out the glove box and attacking it from the back.  It took several days, LOTS of patience and some band-aids, but it is done. THE most difficult part -BY FAR- is to remove and then replace the screw that sits on the actuator arm, connecting it to the fresh…

Continue

Flashers

Posted by Mike Petrey on January 13, 2019 at 12:25pm 7 Comments

Where do the flashers go in my 64 Deville Convert.  I'm thinking that's why both turn signals stopped working.

Source for Motor mounts and Trans mounts 1964 SDV

Posted by Norman Silverman on January 9, 2019 at 4:23pm 4 Comments

Hi.

Where is the best place to purchase good quality motor mounts/trans mounts for my 1964 SDV? I see that Rock Auto has them for $8 and change, and others for $24 and change. Big difference. Is there a better place to buy them from?

Thanks

Norm

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service