I have a 64 and the timing is to far advanced  the vacuum advance hits the valve cover I think this is a result of my father in law having a timing chain put on years ago what is the best remedy ? Pull out housing and reposition it ? Also trying to figure out if maybe they installed the wires  wrong  where exactly should rotor be pointing on TDC ?  and is it possible if it was installed off  that the wires could of been moved on the cap  to make it run .have had this car 27 years and always runs hot and won't start till the engine cools down ( like it is to far advanced  haven't thrown a light on it yet I am doing my homework so when I tackle it I am prepared  I have seen the diagrams here but doesn't really show  clock position of rotor on tdc  any advise is appreciated 

Views: 394

Reply to This

Replies to This Discussion

OK thnk I got the reply and post down  sucks being newbee 

You must have a 1964 series 62 car as they came through with the Jetaway transmission that was used in all Cadillacs from 1956-63 and the 1964 series 62 cars.  DeVille models had the new Turbo Hydramatic which today we call the TH400. 

If you have access to a shop manual, there is a section in there regarding adjusting the linkage to the transmission.  I would be that if you Google it, you will also find the answer. 

This site is great for tech advice, don't be shy. There are always people willing to help you keep it alive and if you decide to sell, there is a section on the site for that as well.

All the best,

Mike 

OK  I am back at it this thing is just Idling to fast  I got totally fed up with it last time now I have to do something with it   but if it runs for 10 mins  it is to hot to restart  It starts and runs fine  It is just to fast at idle  I am at wits end and this car will be causing to have a stroke  I know there must be answers I just can't find them  the carb linkage looks nothing like any posted  and the motors manual I have doesn't address  this problem 

Steve, these cars can be frustrating for sure!  For now, you can disconnect the throttle linkage entirely in order to idle the engine, set the timing, adjust the carb etc.  It sounds like someone may have switched the linkage on you or it is way out of adjustment?  Super fast idle could also indicate a vacuum leak, especially if you hear a "whooshing" sound around the base of the carb.

If you could post a photo of the linkage that may help with diagnosis or identification.

 Thanks I will do that thank you very much for responding 

here they are 

Attachments:

OK I found it  was a cracked hose going to the PCV valve and a bad PCV plugged the port on the carb  now my question is where does the PCV go  it appears to be a hose that disappears under the intake . also can some one point me to detailed instructions for adjusting that TV  down shift rod  my car is holding gears to long I let up on petal and it shifts  a little like a bad modulator valve on a ford  ( my motors only shows a picture of it )  Thanks all for your help 

Steve, you are correct. The PCV hose connects to a breather tube under the intake manifold, towards the rear of the engine.  To access, you will probably have to remove the intake. You may want to replace the hose at this point since you are digging in this far and probably do not want to touch it again. 

You said you have a Motors manual?  I am not sure what year manual you have but the shift linkage from Cadillac '56-'64 Hydramatic (Jetaway) are nearly identical and you can look at the transmission section of the manual for any of those years to see the correct adjustment. Your transmission was used on the series 62 Cadillacs in 1964 and was called a Hydramatic whereas the identical transmission was known as a Jetaway when used in Olds, Buick and Pontiacs. This was the last year Cadillac used that trans in any cars as the Coupe DeVilles used a TH-400 in '64 which became standard across the board in '65.  Best of luck!

The PCV was spliced into that hose and tucked under the manifold  the hose going under seems OK  I just caped the port on the carb to get it to the right Idle when the new PCV comes I should be able to cut that hose back a little and make a new piece between the PCV and carb  as far as linkage gonna dig into that next   I know one way is faster and the other slower  Thanks for the info  I greatly appreciate it 

Steve
What model is the car and where is it located ?

Enjoy

not sure  no name on it  it has 4 doors cloth  seats  and that transmission pretty sure the engine is a 390 her grandmother bought it new in 64  it has been garage kept iout side Chicago since about 1980

Tell us the VIN and we tell what you have, or you can find out yourself from this list:

Suggest you buy a Cadillac Shop Manual if you gonna keep fixing this car.

RSS

Photos

  • Add Photos
  • View All

Forum

New photo gallery

Started by Tony and Ginny 429 in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 46 minutes ago. 8 Replies

Having trouble posting my picture in the new gallery but managed to get the text right The computer WIZ - I am NOT ! Stay safe my friends Continue

New Car Gallery Page Created - Post a Picture of your 1963/64 Cadllac

Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 1 hour ago. 4 Replies

Hello 63/64 Cadillac Website Members,Hope you are all staying safe amid the Coronavirus shutdown and wanted to share something new & fun on the 63/64 Cadllac Website at…Continue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge 3 hours ago. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

1963 coupe deville front relocation shock kit

Started by Daniel Grande in 1963/64 Cadillac Specific Discussion. Last reply by Jason A 11 hours ago. 6 Replies

Howdy everyone had a question maybie you guys can help me,I have a 1963 coupe deville and i got it with air bags problem is its way to bouncy in the front need to get a shock relocatio ok n kit but I…Continue

Blog Posts

How to sensibly deal with the Corona Virus

Posted by Jeff Kinzler on March 14, 2020 at 5:02pm 6 Comments

https://theamericanscholar.org/covid-19-a-primer/

I found this very helpful, written by a knowledgeable authority in public health. 

Remember, Viruses are not spread by Cadillacs so get out and drive!


Safe & Healthy travels. 

Jeff Kinzler

1963 Eldorado convertible boot

Posted by Les Eastling on February 27, 2020 at 10:33am 1 Comment

I need a used convertible boot for a 63 Cadillac convertible - condition or color is not an issue since it will be used as a pattern for making a new one. One from either a 62 series convertible or an Eldorado would work. I know I am searching for hen's teeth here... but you never know unless you ask!

Looking for 63 Convertible / Coupe rear side trim

Posted by Gene McIlroy on January 24, 2020 at 12:18pm 0 Comments

Want to find a good straight dent free rear side trim for my 1963 Convertible.  I have both sides but they do not match.  Wanting to get them to match.  I am attaching a photo of the two trim sided that I have really wanting the squared off trim if I can get it.  Let's see what you have,…

Continue

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service