Anybody know what I need to do to make my trunk stay open. I got this car a few years back and it’s always been like this. I’m trying to everything in working order.

Views: 88

Reply to This

Replies to This Discussion

Hello, As far as I know there are 2 trunk hinge tension rods that hold that open. They are made of spring steel. They have bends to assist opening and hold. Maybe yours are broken or wore out. I'm sure someone has a pair on this site for sale. I  have a pair if interested I can look for them. Also maybe they came out of the area where they are mounted at.

That is one heavy trunk lid
Sure you will be glad to correct that issue soon
Sure the answer will be along shortly

Enjoy

Trunk rods are different for different models. Be sure to get the correct trunk rod set.

Look in your 1963 Cadillac Shop Manual Illustration Fig 16-78 on Page 16-69, then Rear Compartment Torque Rod Adjustment on the next page 16-70 section 80. Rear Compartment Torque Rod Adjustment.

Note that you have 3 positions to adjust the torque rods. The lowest position 1 gives least upward force and the highest position 3 gives most upward force.

If torque rods are in the lower positions move up a notch and try the trunk lid. If all ready at the top #3 position torque rods are probably weak and worn out.

I have a good stock spanning most if not all body styles for $25 each or $45 for a pair of you need them. If you end up needing any email me at jasonedge@nc.rr.com

Here is the illustration you will find in the shop manual:

Thank you! I will check it out and respond one way or the other.

RSS

Photos

  • Add Photos
  • View All

Forum

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge 5 hours ago. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

FUEL GAGE

Started by STEPHEN HORWATH in General Discussion. Last reply by Tony and Ginny 429 16 hours ago. 7 Replies

Hi just wondering if anyone else had a problem with their fuel gauge going up to full when key is turned to the on position or when the car is running.  it goes back to empty when key is in the off…Continue

Front Window Motor Installation Help Needed

Started by Roy in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 yesterday. 9 Replies

I have a bad window motor in the passenger side door.  I have removed the door panel and am at a complete loss as to where to start and what to do from here.  Does anyone have any step by step…Continue

Intake manifold leak

Started by Joe DiIaconi in 1963/64 Cadillac Specific Discussion. Last reply by Roland Moser yesterday. 35 Replies

Anyone install better quality intake manifold gaskets?

Blog Posts

Hood Insulation

Posted by Dominic Salemi on July 3, 2019 at 9:15pm 2 Comments

Can anyone give me some information on what to use to secure my hood insulation to the hood.

Thanks

Dominic

64 Hood Hinge Color?

Posted by Bob Schles on June 27, 2019 at 4:46pm 2 Comments

Can someone tell me what color the hood hinges should be? I've seen both silver and gold cadmium plating colors on the cars. Thanks

Rear Side Window Stainless Sill Removal

Posted by Lee Martin on June 24, 2019 at 3:07pm 2 Comments

I'm looking to replace a piece of the stainless trim that sits on the outside of the car like a sill outside the rear passenger side window.  I can just barely see one screw at one end but does the door panel and/or window need to come out to access this?  If anyone has done this I'd like to learn what is involved.  Here's a photo of the piece I'm talking about:…

Continue

Cadillac Returns to its Roots Under New Leadership

Posted by Jeff Kinzler on May 1, 2019 at 12:30am 3 Comments

Cadillac’s new boss says they should stop trying to build BMWs and go back to building Cadillacs again.

What do you think? 

https://carbuzz.com/news/cadillac-finally-admits-what-everyone-knew-for-years

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service