Hi all. 

It has been a while since i last asked or posted something. My car has his engine put back in and i am now just working om some loose ends.

The last thing i have to do before i can get on the road safely are the turn signal lights.... I just cant get them to work properly. My cornering lights work great when using the turn switch. But none of the lights flash front or back. Sometimes the fender indicator goes on but they don't flash either when using the signal switch.

The light units left and right where not good so i ordered New ones of Russ. They work great on the workbench but not in the car as far as flashing goes. 

I pulled the car apart when everything was working so don't know what happened. 

Thanks! 

Some pictures of the engine bay and more. 

Views: 29

Reply to This

Replies to This Discussion

The very first thing to do with our 55 year old cars --is to be cleaning the grounds for all electrical contacts
A lot will come back to life ( you should be pleasently surprised ) and is a no cost fix
Now that a good thing

Enjoy

Check the turn signal flasher canister. 

You need to remove the pannel at the base of the steering wheel to see the Flasher that Russ makes reference to
Many are silver or gold color
Controls the blinking of the turn signals

enjoy

Thanks guys i have been tampering with ground and bad wires all evening. Luckily i got them to work again.

Thanks! 

RSS

Photos

  • Add Photos
  • View All

Forum

FUEL GAGE

Started by STEPHEN HORWATH in General Discussion. Last reply by Tony and Ginny 429 9 hours ago. 7 Replies

Hi just wondering if anyone else had a problem with their fuel gauge going up to full when key is turned to the on position or when the car is running.  it goes back to empty when key is in the off…Continue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge 22 hours ago. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Front Window Motor Installation Help Needed

Started by Roy in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 yesterday. 9 Replies

I have a bad window motor in the passenger side door.  I have removed the door panel and am at a complete loss as to where to start and what to do from here.  Does anyone have any step by step…Continue

Intake manifold leak

Started by Joe DiIaconi in 1963/64 Cadillac Specific Discussion. Last reply by Roland Moser yesterday. 35 Replies

Anyone install better quality intake manifold gaskets?

Blog Posts

Hood Insulation

Posted by Dominic Salemi on July 3, 2019 at 9:15pm 2 Comments

Can anyone give me some information on what to use to secure my hood insulation to the hood.

Thanks

Dominic

64 Hood Hinge Color?

Posted by Bob Schles on June 27, 2019 at 4:46pm 2 Comments

Can someone tell me what color the hood hinges should be? I've seen both silver and gold cadmium plating colors on the cars. Thanks

Rear Side Window Stainless Sill Removal

Posted by Lee Martin on June 24, 2019 at 3:07pm 2 Comments

I'm looking to replace a piece of the stainless trim that sits on the outside of the car like a sill outside the rear passenger side window.  I can just barely see one screw at one end but does the door panel and/or window need to come out to access this?  If anyone has done this I'd like to learn what is involved.  Here's a photo of the piece I'm talking about:…

Continue

Cadillac Returns to its Roots Under New Leadership

Posted by Jeff Kinzler on May 1, 2019 at 12:30am 3 Comments

Cadillac’s new boss says they should stop trying to build BMWs and go back to building Cadillacs again.

What do you think? 

https://carbuzz.com/news/cadillac-finally-admits-what-everyone-knew-for-years

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service