Hi there--

I don't believe my car has the High 'C' option or at least I don't see a 3rd horn, but I'd like to add one or the Eldorado horn. Does anyone have one they'd mind selling?

I have a 64 Convertible if that matters.

Thanks,

David

Views: 42

Reply to This

Replies to This Discussion

The horn if you can find one WB expensive 

They go for  400 to 600 dollars which is a ball park number based on condition 

Enjoy

I usually have the standard (non-Eldo) shorter "Hi C" trumpet horn but just out. If Russ or no one has one I can put you on the Wait List. The long optional "896" Eldorado horn is like finding hens teeth. I got lucky and found a very nice one a couple years ago and it went on my 64 CDV, which would had been an optional 4th horn complementing the Hi Note, Lo Note, and Short "Hi C" trumpet horn.  The Eldo Horns are out there, but like Tony indicated, they are usually expensive.  If you add back the factory shorter Hi C horn, that would still give you a nicer sound and fill the missing spot for the 3rd horn on your radiator support.

For picture references of the various 1964 Cadillac Horn Setups check out these Help Page Links:

- Horns: 1964 Standard 3 Horn Setup  
Horns: 1964 Eldorado Three Horn Setup
Horns: 1964 Four Horn Setup With Optional "896" Eldorado Horn

I have a good short trumpet horn.  email me at  russ85747@hotmail.com

RSS

Photos

  • Add Photos
  • View All

Forum

Center bearing - replacement.

Started by Anders in Restoration Discussion. Last reply by Norman Silverman 6 hours ago. 23 Replies

Had some sound from the propeller shaft and as the rear wheel bearings just been replaced I thought it would be the center bearing. Removed the propeller shaft and checked the center bearing (as per…Continue

The Central Florida weather could just not get any better !!

Started by Tony and Ginny 429 in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 7 hours ago. 1 Reply

No Description

Wanted: retaining clips for dash pad legs

Started by Mark Geertsma in Wanted to Buy. Last reply by Russ Austin 14 hours ago. 1 Reply

Looking for the retaining clips (L+R) that the "legs" of the dashpad snap into. Mine are missing. Continue

1964 429 & Trans For Sale

Started by Russ in For Sale 22 hours ago. 0 Replies

Anyone in need of a 429 & trans? Was running when pulled from car but had low compression on a few cylinders if memory serves me right. Engine/trans are in Phoenix. Russ, 562.858.6926Continue

Blog Posts

64 Recirc/Fresh Air Door Actuator replaced; FROM THE INSIDE.

Posted by Norman Silverman on February 4, 2019 at 11:21pm 8 Comments

I am happy to report that I have successfully replaced the Fresh Air/Recirc door actuator that is located on the blower box-and have done so without having to remove the blower box. I did it by taking out the glove box and attacking it from the back.  It took several days, LOTS of patience and some band-aids, but it is done. THE most difficult part -BY FAR- is to remove and then replace the screw that sits on the actuator arm, connecting it to the fresh…

Continue

Flashers

Posted by Mike Petrey on January 13, 2019 at 12:25pm 7 Comments

Where do the flashers go in my 64 Deville Convert.  I'm thinking that's why both turn signals stopped working.

Source for Motor mounts and Trans mounts 1964 SDV

Posted by Norman Silverman on January 9, 2019 at 4:23pm 4 Comments

Hi.

Where is the best place to purchase good quality motor mounts/trans mounts for my 1964 SDV? I see that Rock Auto has them for $8 and change, and others for $24 and change. Big difference. Is there a better place to buy them from?

Thanks

Norm

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service