After engine rebuild
Rebuild original (matching number) engine. Had the valve cover powder coated and the embossed Cadillac word powder coated in gold.
Comment
Photos
Members
Forum
Classic Cadillac Parts For Sale - Misc Items
Started by Jason Edge in For Sale. Last reply by Jason Edge 1 hour ago. 161 Replies 12 Likes
I have posted a few Misc items over on my Classic Cadillac Parts Facebook page at…Continue
NOTHING IN MOTORING COULD PLEASE HER MORE!
Started by Jason Edge in Chapter Discussion 4 hours ago. 0 Replies 0 Likes
Ok.. How about one more scan for today from the 1964 Cadillac Mailer I will be including in an upcoming newsletter.…Continue
Discover a New Measure of Automobile Pleasure!
Started by Jason Edge in Chapter Discussion. Last reply by Tony and Ginny 429 7 hours ago. 1 Reply 0 Likes
OK. I'm having fun with this mailer I have scanned in. Cadillac sure had a way with describing their cars back in the day! Here is the back cover of the 6 page mailer you will seen in an upcoming…Continue
Welcome 1963/64 Cadillac Chapter Members
Started by Jason Edge in Chapter Discussion. Last reply by Jason Edge 8 hours ago. 227 Replies 2 Likes
Tags: chaptermember, newmember
Blog Posts
Starter Solenoid replacement-how difficult? Where to buy?
Posted by Norman Silverman on August 20, 2019 at 8:24pm 8 Comments 0 Likes
Hello All.
I believe the starter solenoid has gone bad in my 64 DeVille. When I turn the key, often all I get is a click, then if I try a few times again the starter turns perfectly. All battery cables are on tight and the battery is good. So, I believe this problem is the solenoid. Where do I buy the right solenoid and is it necessary to remove the starter in order to swap it out? …
ContinueFrame Markings
Posted by Gene McIlroy on August 12, 2019 at 6:26pm 1 Comment 0 Likes
Just got my frame back from powder coating so thought I would post photos of the front and rear frame markings.…
Lining up the drive shaft
Posted by Dominic Salemi on August 12, 2019 at 5:47pm 2 Comments 0 Likes
Can anyone shed some light on how to position the complete drive shaft in the correct position? I want to make sure my drive shaft is installed properly.
Thanks
Dominic
Upper A Arm Rubber Bumpers
Posted by Gene McIlroy on August 12, 2019 at 1:30pm 3 Comments 1 Like
I have found a very good replacement part for the Upper A Arm Bumpers. The top part is identical to the originals the bottom can be used as is or after a few minutes with a belt sander can be ground to the V shape as the originals were. The replacement bumpers are for a 2001 to 2005 S10 Sanoma or Blazer. Part number is on the box in the photos. First photo is the box next to the box is the S10 part and an original. Next photo shows my sanded down part next to an original.…
ContinueEvents
© 2019 Created by Jason Edge.
Powered by
You need to be a member of 63/64 Cadillac Website to add comments!
Join 63/64 Cadillac Website