New member here so be patient with me. New owner of what I would consider a rat-rod 63 caddy. Previous owner painted everything flat black, in an obvious attempt in covering up body deficiencies. …Continue
"I have an uncracked left side manifold. Cad # 1475463 It'll need to be sandblasted and the ports trued , as it sat outside for an unknown time. Also have right side one, plus others. Will be offline until this Friday. …"
"Finding these rare dealer installed items in VG used condition is like finding hens teeth ... with gold caps! I would buck up and buy the nice new repros from OPGI. I've pulled in 52 parts cars, maybe 4 had the right sight mirror, 3 were poor…"
"Previous owner basically pulled it out of a field. Painted everything but lenses in a Flat Black. Ex-Florida car, but still spent enough time in NYS that there is rust, I just don't know how much. never going to be pristine, but should make a…"
Hi,I have a huge problem my POWER SECTION of the ``Master-VAC Power Brake unit 9´´Diameter ´´ from Bendix is Broken and I can't open it to replace al the rubber parts did some of you have auch Power…Continue
Did anybody from the club install third brake light in the rear window in his Cadillac? I have problem to figure out how to do it. Can I just run wire from break pedal switch and second wire connect…Continue
Ok, I have another question. Since I will run wire for a brake light I might run speakers wires.I would like to install 2 extra speakers or maybe 4. What is best option. I do have 2 speakers already-…Continue
I have an excellent running 429 with 400 trans.recently removed from my 64. It has electronic ignition, new water pump,new fan and clutch(not pictured),new fuel pump,Holley 650 vac. sec. carb. with…Continue
So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…