I’ve had the car for a couple months now and when closing the trunk the passenger side hinge has always had a small bind but no major issues or struggle to shut. I attempted to close it yesterday and…Continue
"These seem to be better than both Detroit Iron and Dave Gram Auto Literature digital shop manual I purchased. Both of mine are missing the body wiring sections that the found in the 7th link down. Not too mention if you download these you can…"
I’ve had the car for a couple months now and when closing the trunk the passenger side hinge has always had a small bind but no major issues or struggle to shut. I attempted to close it yesterday and it wouldn’t latch and then I noticed it’s way out of alignment. The drivers side is touching the body and the passenger side is out about an inch out. The hinges don’t appear to be bent, no broken welds, no apparent scratches where something shifted. Any suggestions or previous problems?See More
"Welcome to the 63/64 Cadillac Website.
This site is hosted by the CLC (Cadillac LaSalle Club) 1963/64 Cadillac Chapter. Joining the website is free to everyone, however, you must be a CLC member to join the Chapter. - Click…"
I have 3 horns and the only one working is the bottom long one. The 2 round ones are not. I played around with the connections and they seem ok. I tried to check for power but not sure I was doing it…Continue
Dear Gents, just had time to dova compression test on the 429 engine by warming up the engine and removed all plugs and went through cranking without pouring oil into the cylinder since I want to…Continue
Jason, I liked the detail and information you have provided. I would like to do mine similar to yours. Can you help? Do you have trunk material? OPGI is sending the trunk product for my 63 Fleetwood. But it does cover the entire trunk as yours was done. If you do not have can you give me a reference? Thanks!! Bob
I mentioned during the 63/64 chapter zoom meeting on 3/21 that we had installed a car lift in our garage. Someone asked what kind and I didn't have the info at hand, so here is a link to it and also a link to some tall jack stands we use to add more stability to the car and an additional safety factor. There is something about getting underneath one of these cars that makes me a little nervous! …
Just developed a significant leak coming from a freeze plug right over the starter. Would this be considered a "cam plug" i.e. like Dorman 17616DS? Our cars have multiple sizes of plugs on engine block and I want to get the right one. Also, does anyone know how pricey this is for a shop to fix? Thanks!