Good morning to all my fellow 63/64 Caddy friends,I have a problem with my convertible top operation that has left me puzzled.When opening and closing it, the process has become painfully slow. When…Continue
Very same model and exterior colors as my
My leather interior is the same color as the exterior
A wonderful combination especially when my top is down ( almost always in my case )
I see you have 65 rims and caps on the car
"Looks like Tony went into considerably more detail. Again, we have no rule where only one reply per question. In fact, it is better to get feedback from everyone than stay quiet if someone answers something. We all have different…"
"Sounds like the electrical motor part of the hydraulic pump is the problem overheating
You can lube the hydraulic cylinders Arms ---on both sides of the back seat with brake fluid per the manual to see if that allows them to move more freely ( less…"
Good morning to all my fellow 63/64 Caddy friends,I have a problem with my convertible top operation that has left me puzzled.When opening and closing it, the process has become painfully slow. When raising (closing) the roof, it actually stops in the middle of the process and only works after I leave the switch alone for a minutes or two.I thought it might the oil in the pump and followed the Manual to purge and fill it with transmission oil. There was none missing, but followed the steps in…See More
"Welcome to the 63/64 Cadillac Website.
This site is hosted by the CLC (Cadillac LaSalle Club) 1963/64 Cadillac Chapter. Joining the website is free to everyone, however, you must be a CLC member to join the chapter. - Click…"
Sep 18, 2017
Marc Robic is now a member of 63/64 Cadillac Website
I'm looking to replace a piece of the stainless trim that sits on the outside of the car like a sill outside the rear passenger side window. I can just barely see one screw at one end but does the door panel and/or window need to come out to access this? If anyone has done this I'd like to learn what is involved. Here's a photo of the piece I'm talking about:…