Does anyone happen to know the right gasket to use on the ventilator valve connector, where it meets the valley cover? I pulled a crusty gasket off the connector, but can't seem to find the right…Continue
"Russ is right. These are easy to make using a sheet of cork rubber gasket, a utility knife, and a steady hand. The issues is sometimes getting a good template. If you have an old gasket available the easiest method is to lay on a piece of paper and…"
"I have them new from the engine rebuild kits I have brought in over the years and sell for $3 as seen below and can ship from NC to CA 1st class letter rate (no tracking) for $2, or 1st class parcel for $4 (tracking), or 2-3 day priority (tracking)…"
Does anyone happen to know the right gasket to use on the ventilator valve connector, where it meets the valley cover? I pulled a crusty gasket off the connector, but can't seem to find the right replacement online.Thanks!See More
"They are 1 31/64", 6 in block 2, in each cylinder head. For more details in a prior discussion Click Here.I still have a couple of new ones for a buck apiece. If you only need 1 or 2 and interested mine shoot me an email to…"
"Just pulled the front bumper off the parts car, and it has some dents on the bottom. 30.00 plus the ride.
Pics were in the early AM, and I can take better pictures if your interested.
email me at firstname.lastname@example.org Please…"
Had some sound from the propeller shaft and as the rear wheel bearings just been replaced I thought it would be the center bearing. Removed the propeller shaft and checked the center bearing (as per…Continue
I am happy to report that I have successfully replaced the Fresh Air/Recirc door actuator that is located on the blower box-and have done so without having to remove the blower box. I did it by taking out the glove box and attacking it from the back. It took several days, LOTS of patience and some band-aids, but it is done. THE most difficult part -BY FAR- is to remove and then replace the screw that sits on the actuator arm, connecting it to the fresh…
Where is the best place to purchase good quality motor mounts/trans mounts for my 1964 SDV? I see that Rock Auto has them for $8 and change, and others for $24 and change. Big difference. Is there a better place to buy them from?