Needed to replace my rear axle as the old made some weird noice even after replacing the wheel bearings. So in the fall I got another rear axle. Had it blasted and painted and been ready for install…Continue
Hey guysThe convertible finally has some color on it!!Hoping I have it back sometime early next weekThen the long process of putting it back togetherHope you like the picsMarkContinue
As I restore this wonderful car, headaches and gaps in knowledge arise that many of you may take for granted. Where might I find pictures of the jack locations on the bumpers and close ups of the…Continue
The 1963/64 Cadillac Chapter is spotlighted on pages 12-16 in the May issue of Cadillac & LaSalle Club Self-Starter magazine. If you have a membership level that provides online access to the…Continue
Hi every one,
After a long time rebuilding my 63 convertible, i finaly get on the road.
A question if anyone can help me. Can somebody tell me the lenght of the motor oil stick.
the cap was probably broken and welded by the old owner. but i m not sure it's in the right place
i put the right amount of oil in motor, but for the weekly maintenance i would like to do two mark "full and add oil"
So i need the lenght from de cap to the two mark
Offering this newly re-chromed 1963 Cadillac front center impact bar for sale, $100 plus whatever it costs to ship it from Detroit to your location.
The unit fits perfect on driver's side but does not sit flush on passenger side. I am told someone needs to take a wooden block and hammer and bang the passenger side lower corner in to make it fit right. If you know how to do this stuff, this is the piece for you.
Email firstname.lastname@example.org with any questions.…Continue
I am installing front seat belts in 63 coupe the holes were already in floor but I do not know how to route inner belts it appears they go through seat in middle?did not find how to remove center armrest on seat are openings there or do you cut into seat? any help or pictures would be great dan