I cannot figure out how to replace a burned out courtesy light in the right rear door of my 1964 Fleetwood 60 Special. Does anyone know how to do this without taking the whole door panel off? I was…Continue
"Use a small flat ended jeweler's tool or very small screwdriver to gently pull release the 4 tabs on the plastic lens. There at 2 on the top on the ends and 2 on the bottom on the ends. Just start at top and gently pry down. The light are those…"
I cannot figure out how to replace a burned out courtesy light in the right rear door of my 1964 Fleetwood 60 Special. Does anyone know how to do this without taking the whole door panel off? I was hoping the light housing would pop out but it does not seem to do so. Looking at it from below with the bottom of the door panel loosened it looks like one can't replace the bulb without getting the housing out.Any ideas???See More
"Welcome to the 63/64 Cadillac Website.
This site is hosted by the CLC (Cadillac LaSalle Club) 1963/64 Cadillac Chapter. Joining the website is free to everyone, however, you must be a CLC member to join the Chapter. - Click…"
Gentlemen I have a 1964 Sedan De Ville with 20 thousand original miles. I am going to replace the spark plugs. What plug would you recommend? I only drive the car a few hundred miles a year and the…Continue
Want to find a good straight dent free rear side trim for my 1963 Convertible. I have both sides but they do not match. Wanting to get them to match. I am attaching a photo of the two trim sided that I have really wanting the squared off trim if I can get it. Let's see what you have,…
Got a little cabin fever this morning,decided to take a road trip to Hickory Corners Michigan, The Gilmore Museum. It’s about 2 1/2 hours from my home . Place is awesome,I was really impressed. 9A648CFF-E965-4CE0-8E91-8E194AC70DED.jpeg…
I wound up with an extra front cover for my '64 and offering it for sale.
Purchased from a knowledgable part supplier with thorough hands-on knowledge of 63-64 Cadillac engines, who checked the part before sending it to me. The oil pump driven gearSee S bore and the pressure relief piston bore are both .002 over and within the .005…