Last time I tried to use the wipers they wouldn't turn on. Finally, they did. Then I couldn't turn them back off. I had to unplug the wiper motor. The switch action does not feel as tight and definite as it should. I have it out of the car, and want to rehab it. Has anyone here done it? If so, where did you get replacements for the little rivets that hold it together?

Views: 333

Reply to This

Replies to This Discussion

I have never tried to refurbish the wiper dash switch  mainly since I have always had a big stash of them since starting to bring parts cars in in 1997. It is commendable and rewarding to refurbish anything, however, if you just wanted to buy one outright I have good working ones with average faces, minor pitting and wear for $25. If you want something really nice like the one below, I sell for $35.

Very Nice 63/64 Cadillac Windshield Wiper-Washer Switch - $35

I have pulled almost 4 dozen 63/64 Cadillac wiper washer switches over the past 20 years, but this is one of the best looking pieces I have brought in. Price is $35 + s/h. Email me at jasonedge@nc.rr.com

Never tried to refurb a wiper switch either.

Just to add, my wiper switch feels sloppy with little definition of where it's at while sliding it back and forth. My car overall is in excellent shape and I always just thought that is how it came from the factory. 

The one on ours is very good, slides easy and you can tell where each speed selection is without looking, but as they say, it never rains in Southern California too.

I doubt our wipers saw too much action prior to the overseas trip.

Just to add, the wiper switch and the wiper motor need to have a very good ground to work. Check the ground to the wiper motor. It is behind one of the mount bolts. 

The wiper switch grounds at the mount pins.

My wipers don't have any action when sliding the switch or pushing the fluid button. No noise or sense anything is trying to work. I've checked and replaced the fuse. Low priority, but is the ground a good place to start?

The wiper switch needs to be grounded to the frame of the dash. The 2 mount pins act as the ground. 

Then the wiper switch is grounded by a ground strap that is underneath a mount screw. Check the grounds and then perform the wiper motor test that is in the shop manual.

RSS

Photos

  • Add Photos
  • View All

Forum

Modern radio antenna …

Started by Mack in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies

Just replaced radios for the modern radios with Bluetooth and all the dance things and wanted to share how I went around the antenna knob… I’ve installed a regular two way GM window switch in the…Continue

BOOT

Started by John Inglesby in 1963/64 Cadillac Specific Discussion. Last reply by Marty Smith yesterday. 1 Reply

I recently purchased a new boot for my 64 convertible and was wondering how difficult it s to install. I'm not very mechanical. It looks like the chrome piece behind and at top of seats needs to be…Continue

63 Exhaust Hanger Mystery

Started by Mike Travers in 1963/64 Cadillac Specific Discussion. Last reply by Cees de Bunje on Monday. 8 Replies

I'm in the process of installing a stainless steel single exhaust from Classic Exhaust on my '63 Coupe de Ville. I'm running into a mystery regarding my middle exhaust bracket. I have the bracket…Continue

TH400 Dipstick Tube Seal

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb on Monday. 9 Replies

In my “rebuild” of the transmission, I ordered a dipstick tube seal. However, I’m not sure if the right one came or how to best install the seal. I am wondering if anyone has replaced this seal OR…Continue

Blog Posts

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

'63 Eldorado trumpet horn + 2 standard horns restoration

Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment

My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns. 

There is a restoration service called The Horn Works who my son…

Continue

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service