I recently purchased a new reproduced harness connector for my window switch. I pulled to old connector apart and cleaned the contacts to the switch wires and window switches while I had it out. Before I replaced it, my passenger window would go down but not up from the master switch. After replacing it, my passenger window didn't work at all from the drivers side and the rear window would only go down and not back up from the master switch. It was late so I buttoned everything up to put away until today, but when I went to put the drivers window up, I got nothing.
At that moment, I realized none of the windows were working any longer at all. I checked my fuses and it looked like everything was alright. It appears the window switches share the same fuse as the horn and the horn was still working. What would cause all the windows to stop working at the same time? I have a few cracked wires in the rubber boot where the door shuts, but would one of those cause all the windows to stop working? Or could it be the relay?
Tags:
Tony,
I do have a bunch of cracked wires in the rubber boot, but the windows worked before replacing this little connector part. Now after working for a few moments, nothing is working. It is a mess in the boot though. I should have taken a picture of it last night while I was poking around the car.
Ok, so the wiring in the door boot was very sketchily rigged up and I had been moving it around to see if I could make the passenger window work. It must have caused it to come lose.
Also, does anybody have any of these clips that hold the switch tog...
Fusick automotive products inc. has them new. Power window switch retaining clip. You will see the short piece on line, but not the longer one. The longer piece is PWSC605
I didn't see this reply yesterday, but thanks a ton Russ. I had no idea anybody was making these anymore. I'll pick these up and report back. The switch seems to work when held together by hand but isn't holding together well enough with these broken clips.
I'm jealous, that is a good-looking original leather armrest
Started by Russ Austin in For Sale 10 hours ago. 0 Replies 0 Likes
I have 2 working T-3 low beam headlights and numerous T-3 high beam headlights for sale. Low beams are 22 each and high beams are 15.00 each plus shipping. Please email me at russ@thecadishack.com …Continue
Started by Larry Rees in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 11 hours ago. 19 Replies 0 Likes
Neither of my cornering lights are working. I started by focusing on drivers side. I removed the entire assembly and cleaned it up, replaced the wire to the socket, cleaned and lubricated the socket…Continue
Started by Michael Vogler in 1963/64 Cadillac Specific Discussion. Last reply by Tony Prichard 18 hours ago. 7 Replies 0 Likes
My original '64 Devile radio has been rebuild and upgraded. Can't wait to get in back in the car!https://youtu.be/DgYqoV290KwContinue
Started by Doug Scarrow in For Sale yesterday. 0 Replies 0 Likes
Just listed nice 1964 Cadillac steering wheel for tilt column https://www.ebay.com/itm/266781070358. $150 plus $25 USA shippingContinue
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 0 Likes
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Posted by Chase on March 21, 2024 at 5:55am 0 Comments 0 Likes
Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!
Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments 0 Likes
Who rebuilds original AC accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year , There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A What is everyone using ? I would prefer to be as original as possible. Thanks
Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment 0 Likes
My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns.
There is a restoration service called The Horn Works who my son…
Continue© 2024 Created by Jason Edge. Powered by