William R Conte's Discussions (53)

Discussions Replied To (30) Replies Latest Activity

"It isn't. The oil looks fine, and the level did not rise. When I pulled the valve co…"

William R Conte replied Apr 23, 2021 to Head Gasket on 429 - If it were put on upside down, what would happen?

28 Nov 12, 2021

"I'm going to pull the heads off. "

William R Conte replied Apr 23, 2021 to Head Gasket on 429 - If it were put on upside down, what would happen?

28 Nov 12, 2021

"lower hose on pump was first. Upper hose from radiator was second. I thought I hadn'…"

William R Conte replied Apr 23, 2021 to Head Gasket on 429 - If it were put on upside down, what would happen?

28 Nov 12, 2021

"I went through the TH400 from my 64 this past Fall. I went through the entire transm…"

William R Conte replied Mar 13, 2021 to Transmission tail shaft bushing (s) and seal for 64 with TH400

18 Apr 2, 2021
Reply by Norman Silverman

"Thanks for the tip on that oil! I'll try that oil when the break in period is up. I…"

William R Conte replied Feb 6, 2021 to Dino - Hoodless!

9 Feb 6, 2021
Reply by William R Conte

"Jason, you are probably already aware of this, but just in case.... make sure you us…"

William R Conte replied Feb 5, 2021 to Dino - Hoodless!

9 Feb 6, 2021
Reply by William R Conte

"When I followed Jason's link, there is a button that you click to check vehicle fitm…"

William R Conte replied Feb 5, 2021 to Did I make a mistake: fuel tank replacement

10 Feb 5, 2021
Reply by Jason Edge

"I used a single chain, and attached it at pass side rear most intake man bolt hole,…"

William R Conte replied Feb 4, 2021 to Hoisting engine

4 Feb 4, 2021
Reply by Kim K Kaiser

"Are you pulling the transmission with it? If so, I recommend one of these --> htt…"

William R Conte replied Feb 4, 2021 to Hoisting engine

4 Feb 4, 2021
Reply by Kim K Kaiser

"That would probably be a good idea. It would provide some slack for movement. "

William R Conte replied Feb 4, 2021 to TRANSMISSION MOUNT FOR 64 DEVILLE with TH400

8 Feb 4, 2021
Reply by Norman Silverman

RSS

Photos

  • Add Photos
  • View All

Forum

Cadmium Plated Cadillac Bolts - More Used that You Can Shake a Dip Stick At!

Started by Jason Edge in General Discussion 4 hours ago. 0 Replies

I have now had just under 3,500 lb of Cadillac fasteners gold cadmium plated, one thing I don't run out of or have to run down to the hardware store are nuts and bolts.  I just replaced my 20+ year…Continue

Radiator Re-core PLEASE HELP

Started by Scott Santora in General Discussion. Last reply by Dennis P. DiBari yesterday. 4 Replies

I could use some confirmation. I sent out my radiator for my 63 De Ville to get re-cored. Several weeks later, when I went to pick it up from the service vendor, I noticed a large amount of green…Continue

Trivia #29 - What Movie Is this?

Started by Jason Edge in Trivia. Last reply by Cees de Bunje yesterday. 13 Replies

It has been a while since we did some trivia and I was watching a movie last night and saw this 1964 Coupe de Ville that briefly makes an appearance.   The Trivia Question is: What Movie Is this?…Continue

1964 Floor braces rot

Started by Todd Fox in Restoration Discussion. Last reply by Todd Fox on Wednesday. 2 Replies

Has anybody in here found a good supplier of replacement floor braces for the 64 convertibles. Continue

Tags: support, brace, Floor

Blog Posts

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

'63 Eldorado trumpet horn + 2 standard horns restoration

Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment

My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns. 

There is a restoration service called The Horn Works who my son…

Continue

Events

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service