David Thomas's Discussions (138)

Discussions Replied To (135) Replies Latest Activity

"The pinion flange and the drive shaft flange are a slight press fit. Get a screwdriv…"

David Thomas replied Sep 12, 2015 to Trying to remove driveshaft on a 63 from rear end.

3 Sep 13, 2015
Reply by Alexander Dixie

"Correct, rear engine mount is the transmission mount. Yaw & Sway Mounts are on t…"

David Thomas replied Sep 11, 2015 to Engine ticking and vibration

59 Sep 19, 2015
Reply by Clovis

"LOL....I believe you need a new transmission mount. Try Caddy Daddy in California, S…"

David Thomas replied Sep 10, 2015 to Engine ticking and vibration

59 Sep 19, 2015
Reply by Clovis

"Clovis, Something I did with my 63 that helped transmitted engine vibration similar…"

David Thomas replied Sep 10, 2015 to Engine ticking and vibration

59 Sep 19, 2015
Reply by Clovis

"You say you don't remember if there was flow in the radiator. You may need to raise…"

David Thomas replied Aug 19, 2015 to overheating engine

89 Sep 7, 2015
Reply by Tony and Ginny 429

"I would think a damaged impeller would throw the unit out of balance along with goug…"

David Thomas replied Aug 17, 2015 to overheating engine

89 Sep 7, 2015
Reply by Tony and Ginny 429

"http://www.caddydaddy.com/1962-1963-1964-cadillac-oil-dip-stick-tube-reproduction-fr…"

David Thomas replied Jul 28, 2015 to Dipstick Tube

5 Jul 28, 2015
Reply by David Thomas

"It's been several years since I replaced the rear ball joint on my car, but, if I re…"

David Thomas replied Jul 26, 2015 to Rear suspention 1963 coup

2 Jul 26, 2015
Reply by David Thomas

"I would "guess" the flywheel flex plate has failed. I would pull the flywheel inspec…"

David Thomas replied May 9, 2015 to Car won't start or drive

7 Jun 7, 2015
Reply by Jason Edge

"Fatsco Transmission should have the proper O-rings and any hard parts you would need…"

David Thomas replied May 8, 2015 to Hydramatic Swap Info.

6 May 8, 2015
Reply by David Thomas

RSS

Photos

  • Add Photos
  • View All

Forum

1964 left hand (drivers side) headlight door lower trim (boomarang) needed

Started by Michael Francioni in Wanted to Buy 1 hour ago. 0 Replies

Must be in good condition for show car or open to a good donor for rechoming but must be pit free. send info to sanremo120@msn.com along with pictures. Thanks...…...Continue

Caddy Bling

Started by Joe DiIaconi in 1963/64 Cadillac Specific Discussion. Last reply by Joe DiIaconi 1 hour ago. 7 Replies

Continue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge 4 hours ago. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Blog Posts

1964 Cadillac Fleetwood sixty special / transmission dipstick needed

Posted by Pablo on September 20, 2020 at 9:57pm 1 Comment

How are you doing folks, I’m looking for a transmission dipstick, any info I will appreciated, thank you very much

1963 Cadillac hood driver side hinge

Posted by Steven on September 16, 2020 at 9:23am 1 Comment

Hello,

 Does anyone know were I can buy a 1963 Cadillac hood driver side hinge or is there any other hinge that would fit? 

Thanks

Steven

Bad Guage?

Posted by Karl Schwarz on August 26, 2020 at 3:08pm 5 Comments

So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It  it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…

Continue

Website

Posted by Fritz Seitz on August 11, 2020 at 2:35am 0 Comments

I have been working on a website-----www.fritzsautorepair.com-----

Does anyone have suggestions?

Events

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service