I went to check the fluid in the transmission on my 1963 Series 62 convertible and when I pulled on the dipstick ring the whole tube came out. I got it back in the hole, sort of, but it is loose. Anyone else have similar issue and any tips on how to get it seated back in tight? I don't have a lift or an easy way to lift the car and safely get under it.

Views: 21

Reply to This

Replies to This Discussion

The oil dipstick tube bolts to the passenger side exhaust manifold. Did you see a metal tab on the tube with a bolt hole it in it?? If not, it may have broken off. There is also an o-ring inside the the transmission housing where the dipstick tube is inserted. If the o-ring is bad or missing and the tube is not bolted in properly, the transmission will leak like a sieve when the car is parked. Been there, done that.

RSS

Photos

  • Add Photos
  • View All

Forum

Rear glass

Started by David Stapp in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 9 hours ago. 9 Replies

anyone know of a company that makes the rear glass for our cars? I can’t seem to find any. 1964 4 door 4 window hard top.…Continue

front engine pulley removal

Started by tom servas in 1963/64 Cadillac Specific Discussion. Last reply by tom servas 10 hours ago. 7 Replies

Am removing the front cover on our 64 engine with AC. Have all 6 bolts that hold the pulley onto the damper removed, can wiggle the pulley BUT it will not come fully off the damper, Is there…Continue

Where can I buy resistance wire for my 1963?

Started by Tim Walterson in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin 15 hours ago. 3 Replies

Hello - just signed up for this forum - looks like a great resource!  I perused the posts and did some searches.  I see most of the posts related to my questions are about doing away with resistance…Continue

Blog Posts

Is there a separate Starter Relay, or does the Solenoid serve that purpose?

Posted by Norman Silverman on August 30, 2019 at 5:57pm 7 Comments

Hello All.

I will be replacing the starter solenoid tomorrow (actually my mechanic will do the work, I'll just supervise). In checking the FSM electrical schematic and chapter verbiage, I don't see anything that looks like (or is referred to as) a starter Relay. It seems the Starter Solenoid serves the function and there's no separate relay. Right or Wrong?

If wrong, where…

Continue

Starter Solenoid replacement-how difficult? Where to buy?

Posted by Norman Silverman on August 20, 2019 at 8:24pm 8 Comments

Hello All.

I believe the starter solenoid has gone bad in my 64 DeVille. When I turn the key, often all I get is a click, then if I try a few times again the starter turns perfectly. All battery cables are on tight and the battery is good. So, I believe this problem is the solenoid. Where do I buy the right solenoid and is it necessary to remove the starter in order to swap it out? …

Continue

Frame Markings

Posted by Gene McIlroy on August 12, 2019 at 6:26pm 1 Comment

Just got my frame back from powder coating so thought I would post photos of the front and rear frame markings.…

Continue

Lining up the drive shaft

Posted by Dominic Salemi on August 12, 2019 at 5:47pm 2 Comments

Can anyone shed some light on how to position the complete drive shaft in the correct position? I want to make sure my drive shaft is installed properly.

Thanks

Dominic

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service