Views: 359

Reply to This

Replies to This Discussion

Just to note, this looks similar to the horn used in 1963 and 1964, but there were different tone horns (and part #'s) used in 1963 and 1964, so this horn is obviously not an exact original replacement for the full year range stated. It is a nice horn regardless. Here are more details I had posted on the CLC forum:

The 1964 Eldorado came with a Low-C long trumpet horn with slightly different tone than the B-Flat used in 1963 and earlier model years. It was also available as a dealer installed option on other 1964 Cadillacs, giving a full complement of 4 horns! The part # on that 64 Eldo horn is 199 9896 and is stamped 896.  
I finally found a nice one for my 64 Coupe de Ville about a year or so ago. It sure does sound nice. For the eBay horn it would be nice if they posted the part # as Buick, Olds and others also had similar horns available. I got lucky and found the correct original  Eldo horn for my 64, but the eBay horn would be a nice addition to an early 60's era Cadillac regardless.

Everything Jason said is correct.  I used the horn in my 62 and it looked good for car shows. I now have part number correct horn for my 62. I did not advertise it for the 61-64 caddy’s because it’s not part number correct. It does look like one however. 

At age 58, i'm just happy to have a horn period, bugger what note it plays. :-)

Oh I know, i'll go back to my naughty corner now.

It would make an excellent addition to any 1963/64 Cadillac. I was only pointing out additional information about the original horns. If I had not lucked up and found my 896 I would probably be looking seriously at this horn! 

Jason, The horn is stamp 12V 946. Dave

947 is the 61 to 63 Cadillac B-Flat Horn. I bet that was an Olds horn.  Someone with an BOP Master Parts Book could confirm. Either way it would be a nice addition for someone.

How much would something like that be worth?

Kevin

I have seen the long horn sell for 400 dollars in the past for the correct year
200 is a very good price but it is a 62 horn looks like

Enjoy

As noted the 1961 to 1963 Long Trumpet Eldorado horn is a 947 horn, not a 946 horn.  I don't seem to have recorded anything but if memory serves 946 may be the Oldsmobile offering of a very similar horn.  

RSS

Photos

  • Add Photos
  • View All

Forum

Turn signal switch needed

Started by Roy in 1963/64 Cadillac Specific Discussion. Last reply by John Aguilar 19 hours ago. 5 Replies

Looking for a turn signal switch for my '64 coupe DeVille. The mechanic working on it said it's the cause of the passenger rear blinker and brake light not working. This is a big issue since police…Continue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by douglas krathwohl yesterday. 1 Reply

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Caddy Bling

Started by Joe DiIaconi in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 yesterday. 8 Replies

Continue

1964 left hand (drivers side) headlight door lower trim (boomarang) needed

Started by Michael Francioni in Wanted to Buy yesterday. 0 Replies

Must be in good condition for show car or open to a good donor for rechoming but must be pit free. send info to sanremo120@msn.com along with pictures. Thanks...…...Continue

Blog Posts

1964 Cadillac Fleetwood sixty special / transmission dipstick needed

Posted by Pablo on September 20, 2020 at 9:57pm 1 Comment

How are you doing folks, I’m looking for a transmission dipstick, any info I will appreciated, thank you very much

1963 Cadillac hood driver side hinge

Posted by Steven on September 16, 2020 at 9:23am 1 Comment

Hello,

 Does anyone know were I can buy a 1963 Cadillac hood driver side hinge or is there any other hinge that would fit? 

Thanks

Steven

Bad Guage?

Posted by Karl Schwarz on August 26, 2020 at 3:08pm 5 Comments

So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It  it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…

Continue

Website

Posted by Fritz Seitz on August 11, 2020 at 2:35am 0 Comments

I have been working on a website-----www.fritzsautorepair.com-----

Does anyone have suggestions?

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service