Can anyone help identify this part?  It came with my partially disassembled '64 Eldorado. Now attempting to reassemble car with help of a local restoration shop here in Long Island, New York. 

Thanks.

Regards to all,

Jeff Kinzler

Views: 245

Reply to This

Replies to This Discussion

My car is parked in a way so I can't go and check. But if memory serves it does look like the part below the radiator. Have checked my MPB and I can't find it in it either.

That is the Radiator Air Deflector (Parts Group 1.272, Part # 147 9472). It attaches via 4 bolts to the bottom of the radiator support and lips above the front lower center bumper end bar.  It helps funnel air through the radiator by sealing from below and serves as a rock & debris shield. It should definitely be installed on any your car if it has been removed.

Here is a picture of mine:

I'll have to check our car, but I don't recall having that.

It was there from the factory.

... but have often seen them removed and not reinstalled.

Hey Jason, do you have one and if so, how much?

I am out right now. Maybe Russ or one of the others reading this has one. If not, I can add you to my Wait List.

Can you please bung me the wait list.

I'll check with Russ as well, but if you haven't got one, I doubt anyone would. 

Kev, I have one for you.  email me at;  russ85747@hotmail.com 

If its not there you should get it. In your climate it might help cooling the engine as per Jasons: "It helps funnel air through the radiator by sealing from below". My guess he can get you a good one.

Jason, Anders
Thank you very much for your help.
Best regards,
Jeff
Thank you.

RSS

Photos

  • Add Photos
  • View All

Forum

F/S 1963/1964 Cadillac parts

Started by Bob Hoffmann in For Sale. Last reply by Russ Austin 17 hours ago. 7 Replies

1963 center bumper & license guard only.1964 front bumper complete, less license guard1964 lower grille1964 cornering lightsAll these parts are from a California car.1964 dash pad. black, great…Continue

1964 Twilight Sentinel

Started by Charles Fares in For Sale 17 hours ago. 0 Replies

Complete USED Twilight Sentinel from a low-mileage, dry California car.  All components and electrical connectors present, no cut wires, nothing damaged or missing. It's plug and play. Send me an…Continue

Re jetting Carter AFB

Started by Robin Evans in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 18 hours ago. 7 Replies

Is it possible to use Edlebrock main jets and needles in a Carter AFB Carburettor. My 64 Coupe Deville runs duel straight through exhaust and this makes the mixture week in mid range and top end. How…Continue

Tags: Duel, Exhaust:, Straight, through:, Fueling:

I need to buy rim for tire Los Angeles ca

Started by Charles in Wanted to Buy. Last reply by Charles 21 hours ago. 5 Replies

in need or rim for tire Cadillac Fleetwood 64 any one known why i can buy in Los Angeles ca ..hi..thanks 310 309 0332Continue

Blog Posts

Stuck at two red (dash) lights!

Posted by Jeff Kinzler on November 3, 2019 at 10:00pm 9 Comments

I hope someone can help solve these two electrical problems that appeared one after the other.

By way of background: The car, a '64 Eldorado has very limited use. It was at a restoration shop for 15 months until last January-  that supposedly did a bunch of wiring repairs including rebuilding the gas gauge that still hasn't worked properly, and the clock that hasn't worked, and re-soldering the broken wires in the drive door. All window and seat controls appear to be…

Continue

driveshaft help

Posted by wayne weaver on October 9, 2019 at 4:41pm 1 Comment

can anyone help me with a driveshaft ? I have a 1963 Cadillac 62 series 4dr with the hydro-matic trans. I need the male splined shaft on the front of the rear driveshaft section. the piece with the nut attached by clip.id be willing to buy a shaft if its not horribly priced.

Dash removal

Posted by Jake Mickley on October 9, 2019 at 12:06am 9 Comments

Hello everyone,

On a 63 CDV, if a guy wanted to remove the entire dash to get all the metal painted, and do some other things behind there, how would he go about doing that?  I checked here and the shop manual, but can't find a complete guide.

As always, and help or direction is appreciated.  Thanks!

--Jake

Introducing myself

Posted by Gary Marchand on October 7, 2019 at 9:32pm 8 Comments

Thanks for letting me join the club.  Picked up this ‘64 Coupe Deville a few months ago out of Beverly MA, the car has few stickers on it from various Cadillac clubs, didn’t know if anyone might recognize it from it’s “Glory days.” Everything seems pretty healthy except for the body and some very Mickey Mouse repairs, was wondering if anyone had any leads on…

Continue

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service