Good Morning, I have a 64 sedan deville. I have a question regarding the always hot wire (red) that powers the door courtesy lights. My passenger doors both work fine. The drivers side don't. my ground (black wire) has continuity from the light all the way to the door jamb switch, so I know that's not broken. I did have a spot that looked broken in the red wire (in the door jamb), so I spliced and heat shrinked that. Before I covered the splice I checked continuity and that was fine.

My question is, where does the hot wire for the front door courtesy light generate? I traced it into the car from the door jamb, and then it heads down into a bundle of wires (with the original cloth tape) and then heads down to the floor and to the back of the car? I want to check continuity but can find where it gets power? any suggestions?

Thanks, Mike

   

Views: 93

Reply to This

Replies to This Discussion

On our 64 convertible, the power source of interest was a relay located behind the drivers side kick panel.

Also the door panel switch on the drivers door.

RSS

Photos

  • Add Photos
  • View All

Forum

1964 Cadillac Coupe Deville Wiring plan

Started by Kai Dröse in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 10 hours ago. 7 Replies

Hi from germany,i know here is a many content about wiring plans and so on.but i need the correct wiring plan for my new dream car ;) the passenger window does not work…Continue

64 Fleetwood Trans Issues

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 on Tuesday. 10 Replies

I've posted a few times about the strange issue I have with the trans on my 64 Fleetwood. When it gets warm and up to temp, I loose 3rd gear, but I never loose reverse. According to multiple sources,…Continue

New Holley, but which one?

Started by Henrik Sonne in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 on Tuesday. 14 Replies

First I will start by saying, I am a newbie. Recently purchased a ´56 HT, which has a 390" from a ´63 in it. I have decided to put a new Holley on it, but not 100% sure which one would be the best…Continue

Shock absorbers and bolts

Started by Sammy in 1963/64 Cadillac Specific Discussion on Tuesday. 0 Replies

Time again to change my shocks. No matter if Gabriel,  ACDelco whatever - don't last longer than 3 or 4 years.Problem is the rubber parts thats gliding out of the bottom.But now I have another…Continue

Blog Posts

WANTED HARMONIC BALANCER BOLT 1964 DEVILLE

Posted by ANGELO MARTINEZ on July 23, 2023 at 10:44pm 3 Comments

  Hope someone can help me to find the harmonic balancer bolt for my 1964 Cadilac Deville 429 engine

in advance, thank you for your help.

Clock ‘64 DeVille

Posted by Matt Vander Hooven on July 23, 2023 at 7:36pm 2 Comments

Is there still a member in the Detroit area that refurbishes clocks?

Matt VH

Spark Plug Heat Range

Posted by Patrick Westphal on July 7, 2023 at 10:00am 3 Comments

I found a diagram that illustrates the main factor in determining a spark plug heat range that I was trying to describe to you during the chapter get together.

Here it is:

 

The main factor is the length of the ceramic insulator from the middle of the spark plug to the tip (where the spark happens)  

The insulator…

Continue

Lower Front End Ball Joints

Posted by Logan Robb on May 11, 2023 at 9:04am 7 Comments

Good Morning all! 



I took the 64 into the shop to have some adjustments completed and in the process decided to have the lower ball joints replaced as was recommended the last time I had it in. I ordered the parts and came into the shop. They quoted me nearly $500 to replace those lower ball joints requiring nearly 4hrs of labor. Now this is a reputable shop and they know me by name here and they will continue to get my business. I am just questioning what on earth is…

Continue

Videos

  • Add Videos
  • View All

© 2023   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service