Well finally statred the trip from mt to ms. 2100, 32 car hours, so far so good.  Car is packed!  Car tools, construction tools, clothes,  trunk n back seat.  Good mpg,  keep ears on in event of problems.  Toniggt.  Casper, wy, tomoro, raton nm., dallas next the home friday.  No seal leak,  yea!   A few pictures to follow

Car sittn low

Picasso heard bags loading, wasnt gonna get left behind, my schnauzer

Trunk loaded

Gauges look good after 200 miles, volts not hooked up.

Wyoming scape over the hood

Of course, me, cruisin, 60s on 6 on the radio, chewing a cuban

Views: 90

Reply to This

Replies to This Discussion

Kim

Look well prepared for just about anything 

Have a safe journey 

No leak is unbelievable 

This will be one hell of a rms  test 

I think you have licked the problem 

Enjoy 

Like the photo with the car sitting in wide open spaces with the mountains in the background 

Enjoy 

$1200 espresso grinder is a must-have when you travel.  
anyone who thinks that way deserves a car with no leaks. 

that's why your our favorite.

It was only 500 13 years ago,   had a restarant.  I use it every day for super fine grind for turkish coffee

Love the picture with mountains in background. It is screaming to go on the cover of a future Chapter newsletter. Have fun on the trip!

Last day,,4.5 hours to go.  Morning observation.

I hv a manuql temp gauge.  No matter how hard i push, wont go over 178   heater is coolish..  last night, 180 185, had to lower heatvsetting time or two.  

My carb is set for 5500 foot altitude.  Im at 300 now.  Couod that efdect, or is thermostat fading out.

Other than that, things seem ok.  Cnt wait to be done!

You [probably need a 190 deg thermostat

I didnt thinknanything  of it at the time, but i had q little leak atvwater control valve yesterday morn.  I simply tightened the  clamp, and it stopped.  Im gettn no heqt at def or heat.  Jist cold air.  Fqn is blowing.  Would that drop of 6 or 7 degrees of engine heqt make the heater/def go that cold?

Keep in mind the thermostat rating is the temperature the thermostat begins to open. The full open temp is about 15 to 20 degrees above the stated temperature.  This is why our cars with a 180 thermostat usually runs about 195 degrees fully heated if everything else is in good order. 

Also, the stated temperature (+ 15) is not a guarantee of where the car will run at temperature-wise... your car may have over heat for many reasons.   With the complete picture of where and how your temp guage is hooked up, or many other variables with your car I would not have a clue why your temp gauge is showing a cooler than normal temperture for a fully heated car. 

Likewise there are many variable that could affect your heat output but 178 degree coolant in the heater core with a fan blowing on high, with the duct and doors open and pointing in to the cabin correctly, is plenty of heat to keep you toasting. 10 degrees of coolant temperature is not going to make that much difference. My first check would be the hot water control vave which is vacuum controlled and lets the hot water into the cabin and heater core in "heat mode". The 1963 hot water control valve was normally closed without vacuum, meaning if you have a busted vacuum line, or has been disconnected you will never get hot air through your heat system. 

If the hot water control valve is operational and just not getting vacuum you can always T-off vacuum from the intake vacuum fitting to provide full time vacuum allowing hot water to enter the cabin and heater core. This would at least give your car heat at leat through the winter time. 
The bottom line is you need to do more detailed diagnosis on the heat system. 

We had info on thermostats at the Stant site but I see that is a now a dead link so I pointed to our Help Page to the NAPA thermostat info page you can see by Clicking Here

Jason.  It was odd.  After i posted above, i stopped at gass station.  Filled up, noticed engine had warmed to aboit 195.  I turned on the heat just to see what would happen.  It blew me out w gauge at running temp of 178.  Just kept it on for 20 minutes or so.  Turned off, waited 10 minutes, turned back on, it was cool again.  Dont know if that provides better info.  Still cold when i got home

Well, i made it!  Yea!!!  My butt is killing me, 36 hoirs in car.

Funny thing,  i got one block from hpuse, car died at stopp light, i ssid to myself, effin figures!  Mannged to get started wo embarrassing myself to push.  It spit an spuutered home.  I checked timing.  It had creepwd up to about 13!!  Would tjat cause a cut out like that?

Anyway,  will give trip details a little later. Just glad to ne out of the sled!!

RSS

Photos

  • Add Photos
  • View All

Forum

Wire Splicing Basics - Hemmings Article & Recommenditon with Video

Started by Jason Edge in General Discussion. Last reply by Tony and Ginny 429 9 hours ago. 13 Replies

I have to say that Hemmings has some great Help Topics and thought I might incorporate a few on our Help Topic Page. I thought I would start off with a very basic topic -- Wire Splicing.  I will also…Continue

Tags: union, lineman's, western, splice, wire

Classic Cadillac Parts For Sale - Misc Items

Started by Jason Edge in For Sale. Last reply by Jason Edge 12 hours ago. 284 Replies

I have posted a few Misc items over on my Classic Cadillac Parts Facebook page at…Continue

Tags: classic cadillac parts, classiccadillacparts

1963 1964 Cadillac Interior Rear Courtesy Lens Convertible

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge yesterday. 1 Reply

Hi, My lenses in the back seat (1963 convertible) have broken.  I see one set on ebay, but they want a huge amount of money for them (I will make new ones out of acrylic before springing for those…Continue

Voltage regulators???

Started by Thomas Yarri in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 yesterday. 5 Replies

Good afternoon to everyone and Happy Thanksgiving. Does anyone have any idea if these can be serviced or know of where I can acquire a good replacement part. The reason I'm looking is because my…Continue

Blog Posts

1963 & 1965 Distributor

Posted by Martin McKercher on November 9, 2021 at 8:34pm 5 Comments

Hi all
I am looking to have an aftermarket distributor made for these year models.
I have fitted a Holley Sniper to my 63' 390 & want the Sniper to control the timing.

This is in the very early stages so I am looking to see if it is viable.
I understand the purists might see this as sacrilgious but the Sniper has made my car soo much better for me.
I am asking to see if there is any interest?

1964 Eldorado for Sale

Posted by Richard Stanley on October 29, 2021 at 1:41pm 0 Comments

After 26 years as second owner, I have decided to sell my 1964 Eldorado.  Feel free to call me anytime to discuss.

https://www.facebook.com/marketplace/item/1764798240358992/

Best,

Richard Stanley

213 300-4567

What is the color of this 63 Eldorado - aquamarine or green?

Posted by SK on October 24, 2021 at 2:33pm 2 Comments

Hi, 

I really like the color combination of this 63 Eldorado (sold long time ago by Volocars).

The ad states aqua exterior and green interior but unfortunately there is no pic on the cowl tag.   

Is the exterior color ’Frost aquamarine’ and interior ’Beryl’?

Or is the exterior green, ’Frost green’ and interior ’Emerald’?

-Samu…

Continue

Rochester throttle body gasket

Posted by Phil on September 29, 2021 at 8:18am 5 Comments

Hello,  would anybody be able to tell me if I’m using the correct gasket on my Rochester throttle body? It doesn’t  look right to me.  I’m not sure if the carb actually ran with this gasket because I got it used with no history.  Any help would be appreciated …

Continue

Videos

  • Add Videos
  • View All

© 2021   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service