Day 2 start up. - 63/64 Cadillac Website2024-03-28T22:33:56Zhttps://6364cadillac.ning.com/forum/topics/day-2-start-up?commentId=6543066%3AComment%3A271068&feed=yes&xn_auth=noBeen a while since i cked in.…tag:6364cadillac.ning.com,2021-04-30:6543066:Comment:2715752021-04-30T01:02:06.027ZKim K Kaiserhttps://6364cadillac.ning.com/profile/KimKKaiser
<p>Been a while since i cked in. Got bk to montana w car in tow. Had some offline instrction on rochester, tuning etc in the meantime. </p>
<p>Backfiring was from hving 2 & 4 spark wires crossed. </p>
<p>My bent tv rod was preventing the accel from going all the way back, so got idle back to 500 w timing at 7 to 8. </p>
<p>Had some instrction by using both vacuum gauge and rpm tp try and set carb. Not sure were it stands right now. </p>
<p>Engine runs half way between 1/4 andv1/2…</p>
<p>Been a while since i cked in. Got bk to montana w car in tow. Had some offline instrction on rochester, tuning etc in the meantime. </p>
<p>Backfiring was from hving 2 & 4 spark wires crossed. </p>
<p>My bent tv rod was preventing the accel from going all the way back, so got idle back to 500 w timing at 7 to 8. </p>
<p>Had some instrction by using both vacuum gauge and rpm tp try and set carb. Not sure were it stands right now. </p>
<p>Engine runs half way between 1/4 andv1/2 temp while sitting at idle. </p>
<p>I took for short ride today. Thought i had trans prob for first 50 yards. But remebered fluid was out so put 5 quart in. Took about 4 loops around block. Some adjustment gonna be needed at tv rod i think. But engine seemed to feel a bit more strong. </p>
<p></p>
<p>Temp is worrysome though, it was a full 1/2 for the short ride. Going to put infered on it at the temp sensor, see what that says, isvthat a good place to point it for this measurement?</p> I tried to go CW but engine w…tag:6364cadillac.ning.com,2021-04-16:6543066:Comment:2711472021-04-16T13:21:29.395ZKim K Kaiserhttps://6364cadillac.ning.com/profile/KimKKaiser
<p>I tried to go CW but engine wont hold up to run at 450/480. Gonna hv to put on hold for a bit</p>
<p>I am currently putting the car on my trailer and beginning long journey back to montana for summer and tge busy tourist season. Takes me about four grueling driving days to get thrre from MS. I will try to get back on it when i get back settled up there.</p>
<p></p>
<p>I had always hooed from beginning to hv it running by this time, but as tgey say, best laid plans of mice and…</p>
<p>I tried to go CW but engine wont hold up to run at 450/480. Gonna hv to put on hold for a bit</p>
<p>I am currently putting the car on my trailer and beginning long journey back to montana for summer and tge busy tourist season. Takes me about four grueling driving days to get thrre from MS. I will try to get back on it when i get back settled up there.</p>
<p></p>
<p>I had always hooed from beginning to hv it running by this time, but as tgey say, best laid plans of mice and mem.</p>
<p></p>
<p>Thanks to everyone who has had thoughts and comments on my adventure into this rebuild, coukdnt have gotten to this point without everyones help.and thoughts </p>
<p></p>
<p>Kim</p> Yes, i out white out ib the m…tag:6364cadillac.ning.com,2021-04-15:6543066:Comment:2710792021-04-15T03:06:56.922ZKim K Kaiserhttps://6364cadillac.ning.com/profile/KimKKaiser
<p>Yes, i out white out ib the markee</p>
<p>Yes, i out white out ib the markee</p> Read my reply tp Jason above,…tag:6364cadillac.ning.com,2021-04-14:6543066:Comment:2713192021-04-14T21:55:06.484ZKim K Kaiserhttps://6364cadillac.ning.com/profile/KimKKaiser
<p>Read my reply tp Jason above, spells out todays running</p>
<p>Read my reply tp Jason above, spells out todays running</p> Thanks Jason.
I reran it agai…tag:6364cadillac.ning.com,2021-04-14:6543066:Comment:2713172021-04-14T21:54:11.876ZKim K Kaiserhttps://6364cadillac.ning.com/profile/KimKKaiser
<p>Thanks Jason.</p>
<p>I reran it again, chged oil, filter, etc. Pulled valve covers gave everythingva retighten, i may hv actually missed one or two that i had tightened down to abput 50 in my sequencing tightening and missed on the final pull, but evertything is tight now to 75.</p>
<p></p>
<p>Ran about 20 min at 1500 rpm. Was cking for that murkey leaky and itnever materialized, oil was clear as bell after run on stick, were it it had been murkey before the oil chg. So maybe that…</p>
<p>Thanks Jason.</p>
<p>I reran it again, chged oil, filter, etc. Pulled valve covers gave everythingva retighten, i may hv actually missed one or two that i had tightened down to abput 50 in my sequencing tightening and missed on the final pull, but evertything is tight now to 75.</p>
<p></p>
<p>Ran about 20 min at 1500 rpm. Was cking for that murkey leaky and itnever materialized, oil was clear as bell after run on stick, were it it had been murkey before the oil chg. So maybe that tightening up did it. Hope so.</p>
<p></p>
<p>Engine runninf a little hot, like a tiny bit before midway, about the gauge needle. When it shut off whem i tried to decelerate to set timing when i started it back up, it was way over the middle. Almost 75%, so. Not sure what that could be, but it backed up some once i got it running</p>
<p>I kind of dnt think mt distributor is in right. Car idles at 900. If i try to push off the acceleratorvat the carb, car wants to die. So i cnt get it to 450, 80 to set timing at idle.</p>
<p>Anyway, attaching a last video, still getting some backfires. One every other minute or so, and that sort of deep engine kind of backfire, videp isnt picking that up.</p>
<p>3rd day, sthttps://youtu.be/jjn8ef7aEskartup</p>
<p></p>
<p>Picture is from oil chg</p>
<p><a href="https://storage.ning.com/topology/rest/1.0/file/get/8794315681?profile=original" target="_blank" rel="noopener"><img src="https://storage.ning.com/topology/rest/1.0/file/get/8794315681?profile=RESIZE_710x" class="align-full"/></a></p> Kim, congrats on the start up…tag:6364cadillac.ning.com,2021-04-14:6543066:Comment:2712432021-04-14T18:31:06.828ZJason Edgehttps://6364cadillac.ning.com/profile/jasonedge
<p>Kim, congrats on the start up. The engine seems to be running smoothly. Normally you woudl change oil at 500 miles (or at least by 1000 miles) but since oil is milky you would want to change and monitor closely. This may be due to various leaks, but otherwise the oil should remain quite clean until you do that 1st oil change. Let us know if oil stays clear after change. If it is getting milky again it cut point to leaking or bad head gasket seal, etc. Hopefully, it is just one of the prior…</p>
<p>Kim, congrats on the start up. The engine seems to be running smoothly. Normally you woudl change oil at 500 miles (or at least by 1000 miles) but since oil is milky you would want to change and monitor closely. This may be due to various leaks, but otherwise the oil should remain quite clean until you do that 1st oil change. Let us know if oil stays clear after change. If it is getting milky again it cut point to leaking or bad head gasket seal, etc. Hopefully, it is just one of the prior leaks you have addressed. Good luck.</p> Nvr got reslly low enough to…tag:6364cadillac.ning.com,2021-04-13:6543066:Comment:2712342021-04-13T23:16:14.723ZKim K Kaiserhttps://6364cadillac.ning.com/profile/KimKKaiser
<p>Nvr got reslly low enough to test at 480. Tried to keepit upfor breakin</p>
<p>Nvr got reslly low enough to test at 480. Tried to keepit upfor breakin</p> Probly chg oil tomoro, its m…tag:6364cadillac.ning.com,2021-04-13:6543066:Comment:2713122021-04-13T23:14:37.606ZKim K Kaiserhttps://6364cadillac.ning.com/profile/KimKKaiser
<p>Probly chg oil tomoro, its milky. B4 running again</p>
<p>Probly chg oil tomoro, its milky. B4 running again</p> Yep. New plugs at 35 gaptag:6364cadillac.ning.com,2021-04-13:6543066:Comment:2713102021-04-13T20:04:34.811ZKim K Kaiserhttps://6364cadillac.ning.com/profile/KimKKaiser
<p>Yep. New plugs at 35 gap</p>
<p>Yep. New plugs at 35 gap</p> 63 cadillac rebuild start num…tag:6364cadillac.ning.com,2021-04-13:6543066:Comment:2710652021-04-13T19:03:39.234ZKim K Kaiserhttps://6364cadillac.ning.com/profile/KimKKaiser
<p>63 cadillac rebuild start number 2<br/><a href="https://youtu.be/7qbpka2rCCc" target="_blank">https://youtu.be/7qbpka2rCCc</a></p>
<p></p>
<p>Video of second day at .13 and .17 i think there is that sort of clank or pop i hear sort of insidr the engine</p>
<p>63 cadillac rebuild start number 2<br/><a href="https://youtu.be/7qbpka2rCCc" target="_blank">https://youtu.be/7qbpka2rCCc</a></p>
<p></p>
<p>Video of second day at .13 and .17 i think there is that sort of clank or pop i hear sort of insidr the engine</p>