De-Yellowing Convertible Rear Plastic Windows by Jaye Koppenhaver

We recently featured the Tech Tip De-Yellowing Convertible Rear Plastic Windows by Jaye Koppenhaver in the February 2017 63/64 Cadillac Chapter Newsletter. I have uploaded it to our website and will link to this thread in from our Help Page.

Here is the link to the article: De-Yellowing Convertible Rear Plastic Windows

Views: 1636

Reply to This

Replies to This Discussion

Excellent tech tip.

Looking foward to using this tip as soon as the temps go back to 80 degrees as sunlight is a big part of the fix
I wish we would have had a --before picture -of the rear window in the article so we could see how far the window came back to life
Sure somehow there are different degrees of damage done to a convertible rear window from the exterior elements
I will report back when i get to do this to my rear window some time in the future
I just love it when i see a clean rear covertible window on our year cars as it is so large clean and fresh looking

Enjoy
Over looking the article again that first photo on top of the article could be the before photo ( has a lot of reflection in it and brown grass )
If so his rear window was not in very bad condition to start with but most certainly came back to better

Enjoy

I wish I knew about this sooner. I decided to get a new rear plastic window because of the yellow and I saw some cracking. What I do now is before I put the top down which is a map folding science all its own is to unzip the window and lay it open in the trunk. I also with the new window began using some stuff I have used for years on my boat plastic side windows called Klear-To-Sea. It has a cost to it but it does do what the label says, namely anti-fog, anti finger print, anti-smudge, reduces glare, and semi repairs small not too deep scratches. I'm not pushing the product but it works on the boat where if the same stupid stuff happened in my car those people would be walking    

Not sure how the window can sit in the trunk unless you mean the convertible top well that the top goes into when it is down

Do lube the zipper
A candle is good to do that
If you damage the zipper from constantly removing the window you will have a new set of problems to deal with so just a heads up
With age the zipper can get brittle and could be a problem not sliding or the material ripping again mostly with age
Your zipper is most likely new now but constant use of it could very well cause a problem with it some time on it in the future

Having owned convertibles all my life i would recommend dusting off the convertible top and rear window EVERy time you put the top down
The dust or any grit can be nasty on the clear rear window having a sandpaper kind of effect on it Going down and folding as it does

I use a top sealer after the white top is very clean that puts a nice shine on the white top
I seal the back window with Armorol and keep all dust and grit off the clear window cleaning it often
Do keep those very large very beautiful clear rear convertible top windows just that way

Enjoy

The convertible top manual (previously posted on this site), suggests releasing the top from the front windshield locks to reduce strain before unzipping the rear window.

RSS

Photos

  • Add Photos
  • View All

Forum

Web site up with a new design.

Started by Russ Austin in General Discussion. Last reply by Russ Austin 12 hours ago. 2 Replies

My web site has been down for a few months and I migrated to GoDaddy.com  Best move ever!My new web site rocks, hope you enjoy it.  …Continue

Had the 64 convert out for some Cruising around the town

Started by Tony and Ginny 429 in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 yesterday. 5 Replies

It is 74 degrees sunny and dry in central Fl - what a day !! - Top Down of coarse The usual OOH’S and AH’S people encircling the car when parked -  a NICE yelling from a car  —and a what year is that…Continue

The 64 - 429 Cadillac gas engine —-is a special unique torque monster ! !

Started by Tony and Ginny 429 in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies

The 64 Cadillac gas engine is a torque monster —with 480 ft lbs of toque at 3000 RPMs Out of curiosity I looked up my 409 dual quad  425 HP  race engines   specs and it has only 425 ft lbs of torque…Continue

Blog Posts

Oil pump

Posted by Ray Schick on October 30, 2022 at 4:34pm 4 Comments

I removed the front cover to change out the timing chain & gears all that went pretty well when I put the cover back on I put in a fresh oil filter ,filled it up figured it would be enough to prime the oil pump when I started the car .Fired up the car and heard lifters rattling, So I shut the car down right away. So I removed the oil filter housing, and poured oil down the neck of the oil pump housing filled it up and filled up the filter put it all together and fired it up and same…

Continue

Available parts

Posted by Thomas Reichenberger on October 13, 2022 at 11:47pm 0 Comments

Caddy members, I’m upgrading my 64 2-door coupe deville.

motor guy lost my block (machine shop went under) so I’m replacing motor & tranny with LS conversion. I have motor parts (other than block) for 429, rebuilt transmission, converter, and too many other motor parts not needed with fully dressed LS going in.

Email me (Tom.reichenberger@ipsper.com) or call me (210-739-4854) if you’re interested…..I live in San Antonio, TX.

thanks, TX…

Continue

Trunk Open and Lock Mechanism is in Closed Position

Posted by Chris Anderson on September 13, 2022 at 7:14pm 7 Comments

While working on my trunk lock on 64 Cadillac, I mistakenly closed the locking mechanism while the trunk was open.  Is there an easy way to manually release the lock back to the open position?

Thanks.

Fuel Pump Failure

Posted by Jon Shields on August 6, 2022 at 6:48am 4 Comments

Hello,

I'm located in Melbourne, Australia and my 64 sedan de ville is stuck in the garage due to failed mechanical fuel pump. The first after market mechanical fuel pump lasted a few years before it failed & left me stranded 5 hours from home. A hire car and tow got us home. On inspection, I noticed a valve not seated within the housing. I was optimistic, pressed it into place and assumed the pump was good to go. But alas, no. From what I can now determine, the diaphragm pushrod…

Continue

Videos

  • Add Videos
  • View All

© 2022   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service