headlight and cornering light filler seal kit....where do these mount

I bought the headlight and cornering light filler seal kit from rubber the right way. I looked all over the interwebs for pictures and I have no idea which pieces go where...pictures would be very helpful. Its 6 pieces total 3 for each side. Here is a link..

https://www.rubbertherightway.com/1963-cadillac-restoration-parts-h...

THANK you!

Views: 147

Reply to This

Replies to This Discussion

Inside the front fenders behind the headlights. It prevents dirt and debris from building up in the headlight bucket area.

there are three different pieces for each side, they were so torn up that i trashed the originals and i cant tell which new one goes where. any chance I could bother you for a picture?

I'm away from the car for the next week or so. It may be shown in the shop manual 

RSS

Photos

  • Add Photos
  • View All

Forum

is there a body manual?

Started by john kilbourne in 1963/64 Cadillac Specific Discussion 9 minutes ago. 0 Replies

I have an original shop manual for the 64 deville. Is there a separate printed body manual?Continue

wanted, '64 tilt turn signal switch WITH cornering contacts.

Started by john kilbourne in Wanted to Buy 11 minutes ago. 0 Replies

I have the regulra one.Continue

Convertible Top Pump Leak

Started by Lee Martin in 1963/64 Cadillac Specific Discussion. Last reply by Mark S Anderson 1 hour ago. 8 Replies

Does anyone have experience with leaky pump or connections to pump?  I have a slow one and it's driving me crazy trying to see where the fluid is coming out.  It is definitely from the pump area (not…Continue

Fuel gauge access

Started by Tosh Dickenson in 1963/64 Cadillac Specific Discussion. Last reply by Tosh Dickenson 2 hours ago. 14 Replies

Do I really have to remove the dash pad to access the back of the instrument panel..specifically the fuel gauge.  1964 DevilleContinue

Blog Posts

63 Caddy Horn

Posted by Robert Alan Shannon on May 27, 2020 at 9:25am 10 Comments

 Just noticed a 1963  Caddy trumpet horn on Ebay. No part # given but some of his other items are 1963 specific, just throwin this out there, I have no connection to this listing .

Wiring connection help.

Posted by Jimmy Davis on May 24, 2020 at 9:15pm 2 Comments

Can someone help me figure where these connections go? I have a 64 60 special if it matters.…



Continue

Wood grain finally done.

Posted by Jimmy Davis on May 20, 2020 at 4:57pm 3 Comments

After years of wanting to, I finally redid my wood dash paneling on my 64 60s. Not too hard to do either.…

Continue

390 engine replacement needed

Posted by Jason on May 18, 2020 at 7:54pm 1 Comment

I’m looking for a 1963 Cadillac 390 engine that runs. 

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service