I have a question about the padding  used between the  headliner and  interior roof of hardtops . It's abt 1/8" thick and  I  want to remove this from my parts car because I use it for storage ; with the headliner badly torn , it's making a mess.  I figure with the  period these cars were built , possibility  of asbestos  exists . If so, I'll probably  just use a roller and paint over it . Comments?

Views: 141

Reply to This

Replies to This Discussion

If the headliner is no good and just using for storage I would rip out the headliner, rip out the insulation, and remove the listing wires (thin rods that run from side to side that support the headliner) and # them front to rear if you plan to reuse. That insulation is very flammable and is a mess once it starts coming a part and don't mess around with it and trash it and save the listing wires from all of my parts cars. Some body styles, and depending on production date, had removable center roof bows. I will also remove those. If they are welded in place I usually leave them for the metal yard..  If you plan to replace the headliner with original or something similar be sure to save a good sample of it. Be sure to also note the trim code on the body plate on top of cowl. I usually save mine in an air tight bag and note the body style and trim code. 

 Thanks Jason,   yes , I want to just get rid of the headliner and  padding , it's  never gonna be on the road again. Until I can find out about possible asbestos , this project's on hold ; I'll move onto something else. Guess I could wear a filter mask , but afraid I'd start a  PANIC!

Not sure.. I've ripped 51 of them out, no mask and still here.  If concerned I would wear the mask. It doesn't take but a few minutes to get it out and if you think it does have any carcinogens, it is probably going to do you more long term damage if it just remains there above your head especially if it is already coming apart and out.

Thanks again, Jason. A very valid point indeed !  Yeah, I'll just wear a filter mask, I can just explain if the county health dept  shows up ; only half kidding! The people around here, Jeesh!

RSS

Photos

  • Add Photos
  • View All

Forum

Modern radio antenna …

Started by Mack in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies

Just replaced radios for the modern radios with Bluetooth and all the dance things and wanted to share how I went around the antenna knob… I’ve installed a regular two way GM window switch in the…Continue

BOOT

Started by John Inglesby in 1963/64 Cadillac Specific Discussion. Last reply by Marty Smith yesterday. 1 Reply

I recently purchased a new boot for my 64 convertible and was wondering how difficult it s to install. I'm not very mechanical. It looks like the chrome piece behind and at top of seats needs to be…Continue

63 Exhaust Hanger Mystery

Started by Mike Travers in 1963/64 Cadillac Specific Discussion. Last reply by Cees de Bunje on Monday. 8 Replies

I'm in the process of installing a stainless steel single exhaust from Classic Exhaust on my '63 Coupe de Ville. I'm running into a mystery regarding my middle exhaust bracket. I have the bracket…Continue

TH400 Dipstick Tube Seal

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb on Monday. 9 Replies

In my “rebuild” of the transmission, I ordered a dipstick tube seal. However, I’m not sure if the right one came or how to best install the seal. I am wondering if anyone has replaced this seal OR…Continue

Blog Posts

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

'63 Eldorado trumpet horn + 2 standard horns restoration

Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment

My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns. 

There is a restoration service called The Horn Works who my son…

Continue

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service