Hurricane Ian bounced fence posts on my 1964 SDV hood and trunk **** need both with hinges in cape coral florida

bought back my hurricane totaled 64 SDV from Hagerty. So one step forward three steps back- Looking for a donor car near by for hood and trunk + an upper trunk lip between rear window and trunk, and maybe some other sheet metal, the hood flew open and flopped a bit- but didnt break the new windshield!! I have the running 72k motor and trans removed and palletized for trade or sale- LS swap is new direction. Any help greatly appreciated -- can drive for pick up // and or delivery of 429/t400 thanks, and Cruella Deville also thanks you!!

Views: 60

Reply to This

Replies to This Discussion


Enjoying your determination to get your  hurricane damaged  Antique Cadillac back in order 

Feel bad for your set back —but like the way you chose to resolve the problem 

You have to be having a  very deep affection for that Cadillac which I understand  to be doing what you have chosen to do moving foreword 

Your story is an inspiration to all on the quest to bringing these great Cadillacs back to there  original Glory 

We are on the same page - my friend regarding this subject 

Enjoy 

RSS

Photos

  • Add Photos
  • View All

Forum

Dino Waiting on Battery!

Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Doug Meloan 1 minute ago. 3 Replies

This past Tuesday I realized I had not cranked Dino, my 64 CDV in a few…Continue

Tags: replacement, battery

People and our year Cadillacs

Started by Tony and Ginny 429 in 1963/64 Cadillac Specific Discussion. Last reply by C. Van Tune yesterday. 1 Reply

So I am doing 5 miles an hour in a parking lot As the window of a car going the other way—-  passes  by my drivers  window the guy yells 61  loud !! —-( some what surprising me so loud ) ———and I…Continue

intake manifold gasket from olsen

Started by austin Rock in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 on Friday. 3 Replies

hi guys im a new 64 caddy owner and im having vaccumm leaks from the intake manifold. i took the manifold off today and it has cracks on it. my question here is, with the olsen gaskets with block off…Continue

1964 FLEETWOOD

Started by Michael Francioni in Wanted to Buy. Last reply by Michael Francioni on Friday. 2 Replies

Anyone have a turbo hydra matic transmission oil pump assembly?Continue

Blog Posts

Need help with a hood latch

Posted by Curtis Dover on January 2, 2023 at 5:23pm 0 Comments

Hey guys, I need some help.  Could someone send me some pictures on how the first hood release lever on a factory 1964 Cadillac is set up, where it comes though the grille. Not the secondary one. I need to know where the thumb or finger position is located through the grille. Is it above or below the center grille molding piece? Mine seems to be positioned behind the center molding piece and will not adjust above or below the molding. I have a wire tied to it to release it…

Continue

Oil pump

Posted by Ray Schick on October 30, 2022 at 4:34pm 4 Comments

I removed the front cover to change out the timing chain & gears all that went pretty well when I put the cover back on I put in a fresh oil filter ,filled it up figured it would be enough to prime the oil pump when I started the car .Fired up the car and heard lifters rattling, So I shut the car down right away. So I removed the oil filter housing, and poured oil down the neck of the oil pump housing filled it up and filled up the filter put it all together and fired it up and same…

Continue

Available parts

Posted by Thomas Reichenberger on October 13, 2022 at 11:47pm 0 Comments

Caddy members, I’m upgrading my 64 2-door coupe deville.

motor guy lost my block (machine shop went under) so I’m replacing motor & tranny with LS conversion. I have motor parts (other than block) for 429, rebuilt transmission, converter, and too many other motor parts not needed with fully dressed LS going in.

Email me (Tom.reichenberger@ipsper.com) or call me (210-739-4854) if you’re interested…..I live in San Antonio, TX.

thanks, TX…

Continue

Trunk Open and Lock Mechanism is in Closed Position

Posted by Chris Anderson on September 13, 2022 at 7:14pm 7 Comments

While working on my trunk lock on 64 Cadillac, I mistakenly closed the locking mechanism while the trunk was open.  Is there an easy way to manually release the lock back to the open position?

Thanks.

Videos

  • Add Videos
  • View All

© 2023   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service