Is it possible to use Edlebrock main jets and needles in a Carter AFB Carburettor. My 64 Coupe Deville runs duel straight through exhaust and this makes the mixture week in mid range and top end. How can I improve fuelling. 

Views: 100

Attachments:

Reply to This

Replies to This Discussion

Edelbrock rods & jets fit.

Thanks. That's good news for me

Robin 

Do this — Call the Edelbrock techs  regarding your problem 

Give them the numbers on you primary  and secondary jets and your metering rods 

The parts are the same for both carbs 

You will find they are very very helpful  “performance guys “

You will need to be checking your spark plug color after your adjustments 

Your mixture WB right when your plugs burn a brown paper bag color 

I would do a complete tune including ign wires to have the engine on tune spec ( vacuum issue free ) and then do the jetting as I did do on my own 64 429 

Enjoy 

Thanks Bud

Robin, if you are dead serious on getting the mixture right and the car tuned perfectly, pick up an Edelbrock air to fuel mixture monitor. https://www.summitracing.com/parts/edl-6593?seid=srese1&gclid=E...

I put a bung in my 63 and 72 chevy truck.

Yes I have bin thinking about that. Looks the way to go. Thanks Bud

I deleted two of my posts 

Enjoy 

RSS

Photos

  • Add Photos
  • View All

Forum

1964 left hand (drivers side) headlight door lower trim (boomarang) needed

Started by Michael Francioni in Wanted to Buy 47 minutes ago. 0 Replies

Must be in good condition for show car or open to a good donor for rechoming but must be pit free. send info to sanremo120@msn.com along with pictures. Thanks...…...Continue

Caddy Bling

Started by Joe DiIaconi in 1963/64 Cadillac Specific Discussion. Last reply by Joe DiIaconi 1 hour ago. 7 Replies

Continue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge 4 hours ago. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Blog Posts

1964 Cadillac Fleetwood sixty special / transmission dipstick needed

Posted by Pablo on September 20, 2020 at 9:57pm 1 Comment

How are you doing folks, I’m looking for a transmission dipstick, any info I will appreciated, thank you very much

1963 Cadillac hood driver side hinge

Posted by Steven on September 16, 2020 at 9:23am 1 Comment

Hello,

 Does anyone know were I can buy a 1963 Cadillac hood driver side hinge or is there any other hinge that would fit? 

Thanks

Steven

Bad Guage?

Posted by Karl Schwarz on August 26, 2020 at 3:08pm 5 Comments

So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It  it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…

Continue

Website

Posted by Fritz Seitz on August 11, 2020 at 2:35am 0 Comments

I have been working on a website-----www.fritzsautorepair.com-----

Does anyone have suggestions?

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service