I need to remove my door panels as I'm getting ready to do some bodywork. How do the ventilator window handles come off. I need to remove them to get the panel off. My door panels are pretty trashed along the bottom as well so I need to replace them at some point.
The floor repair ,you plan on doing ,feels like it could be difficult ,due to the way it was repaired in the past
Like to know what your plan of attack is ,regarding replacing the floor pans ,in this case ,and condition
Is it most common to cut the bad out and weld or braze new in ?
Just like to know a little of what goes into ,replacing the less than solid ,floor pans
It's not difficult just time consuming. I'll get all of the previous repaired floors out first. They were riveted over the bad floors. From under the car drill guide holes along the floor braces so that I don't cut through them. Cut the old floors out back to good metal. I will then clean up the floor braces.
I'll then Cleco in the new floor pan temporary and with a sharpie trace on to the new pans. Trim to fit and then I will tack in place moving around from side to side to prevent heat build up with a mig welder. I have some body braces to repair as well. I cut good ones out of the 63 parts car I had. I'm off this week from work due to spring break so plan to get a lot of it done this week. It's a lot of work but I had to do the same on my 50 Chevy.
The backup lights worked on my '63 Series 62 convertible when I bought it in July, but have stopped working. All other lights work fine. There is no power coming to the connectors behind the license…Continue
Gentlemen I have a 1964 Sedan De Ville with 20 thousand original miles. I am going to replace the spark plugs. What plug would you recommend? I only drive the car a few hundred miles a year and the…Continue
Want to find a good straight dent free rear side trim for my 1963 Convertible. I have both sides but they do not match. Wanting to get them to match. I am attaching a photo of the two trim sided that I have really wanting the squared off trim if I can get it. Let's see what you have,…
Got a little cabin fever this morning,decided to take a road trip to Hickory Corners Michigan, The Gilmore Museum. It’s about 2 1/2 hours from my home . Place is awesome,I was really impressed. 9A648CFF-E965-4CE0-8E91-8E194AC70DED.jpeg…
I wound up with an extra front cover for my '64 and offering it for sale.
Purchased from a knowledgable part supplier with thorough hands-on knowledge of 63-64 Cadillac engines, who checked the part before sending it to me. The oil pump driven gearSee S bore and the pressure relief piston bore are both .002 over and within the .005…