Can I obtain a complete neutral safety switch and plug for a 64 switch. 
- Non-Tilt/Turbo Hydramatic          - Part # 199 3652 (652 stamped on switch)

Then rewire my existing wiring to the new plug? Or can I just rewire my existing NSS? 

 My concern is I have changed the shift pattern from PND1D2R to PRNDL

Oh, I have a 63 convertible. 

Thanks

Views: 151

Reply to This

Replies to This Discussion

There is information in the Help topics on transmission swaps https://6364cadillac.ning.com/profiles/blogs/enginesandtransmissions

 Thanks for the reply. Yes, I read that help section several times before I ventured into this project. A lot has changed in the ten years since it was written many parts are readily available that were not then. I’m in too deep to turn back now. Some fab is still needed. 

I still have the question if I can just rewire my existing switch (the preferred option) or would a switch from a 64 be the way to go?

Thanks

Attachments:

I would be curious if you can post a list of the parts that are now readily available that were not when originally posted.  Other than the aftermarket adaptor ring I occasionally see, the THM kickdown switch, I have seen,  the longer front driveshaft section, different yaw mounts,  different carb mounting boss for switch, neutral safely switch differences and issues, shift quadrant indicator, and most importantly the different diameter (3 1/16" vs 3")  in raised mounting area off back of crank for for THM flex plate vs HM drive plate are still issues that you will have to deal with.  A THM flex plate will have to be enlarged to fit the back of the HM crank and it has to be done perfectly.    Thanks, Jason.

Jason,

Speed Gems has a complete adapter kit that addresses the different diameter and flex plate issues.

https://transmissionadapters.com/collections/cadillac/products/1954...

Caddy Daddy has yoke, https://www.caddydaddy.com/shop-parts/drive-line/yoke/1959-1960-cad...

Universal joint and trans tall mount

https://www.caddydaddy.com/1959-1960-cadillac-custom-cross-series-u... https://www.caddydaddy.com/1955-1956-1957-1958-1959-1960-1961-1962-... and an explanation on the mod to the cross member. We still have to address linkage and shift quadrant indicator. As I mentioned I need to address the NSS and possibly front drive shat shortening.

Thanks

Woah! $900. It is neat to see that mounting kit but you have other issues to deal with. 

As far as the yoke, you still need to install on an original driveshaft front section. The front sections are readily available.  It is the rear that is the issue. I have several VG condition for $100 for the HM front which is $165 less than the $265 Caddy Daddy is charging and you still have to have it installed. I am also not sure about the integrity of just extending the yoke length.  Under normal driving condition I would guess that would be OK.  That is basically extending the flexpoint further back from the tail shaft. In a 4x4 that would be a big non-no, but on an old Cadillac should be a good alternate solution.

Jason,

I listed the yoke for information only for others if they are interested. We will not be using  the extended yoke. I'm using a TH400 with a 9" tail which is a a little longer overall then the Hydramatic. I had the same thought as you on the extended yoke. We will shorten the front shaft. This is a neat project that will be great when complete. I have a very accomplished mechanic with great fab skills. I'm sure there will be several trial and errors before complete.

The shift pattern is different, so ytou will need the 652 NSS.  However, the 652 will not bolt up to the 63 column.  You will need to swap out to a 64 non tilt THM column.   

Or you can jump the starter wires together and drive the car without back up lights. 

Thanks Russ, I was afraid a column swap was in to mix. 
I may go with the second option for now. Step back and regroup. Should be on the road in a couple of weeks. 

Thanks for the replies. 

RSS

Photos

  • Add Photos
  • View All

Forum

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge 20 hours ago. 1 Reply

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

A word of caution about using Stock Interiors/Auto Custom Carpets

Started by Chris Gill in Restoration Discussion. Last reply by Chris Gill on Wednesday. 4 Replies

Hi Folks, Just a word of warning here. Take it or leave it... I purchased almost $1,000 worth of carpets, custom mats, and bulk carpet from Stock Interiors over the past year for my 1963…Continue

AC Trouble shooting Help?

Started by William Mott in 1963/64 Cadillac Specific Discussion. Last reply by Kurt on Wednesday. 12 Replies

Good Evening all,I just got the 63 caddy back on the road: cleaned up the tank, new sending unit, new Edelbrock electric fuel pump, and Edelbrock relief valve.  Still had some vapor lock, but…Continue

Tags: AC

Let's Pop the Cork!

Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 on Wednesday. 10 Replies

I have been intermittently working on parts Car #55, a 1963 Series 62 Four Window Sedan, between work on my new house addition project (ready to start floor framing once foundation and drainage is…Continue

Blog Posts

I was working on my HVAC system this winter and during the process of taking the dash pad off these two parts fell out. Does anyone know what they are and where they go?

Posted by Patrick Westphal on April 12, 2022 at 1:35pm 1 Comment

I was working on my HVAC system this winter and during the process of taking the dash pad off these two parts fell out. Does anyone know what they are and where they go?

Continue

1964 Cadillac Coupe DeVille Convertible Speedometer Bulbs

Posted by Russell L Parr on April 1, 2022 at 9:15pm 6 Comments

I need to replace the bulbs for the speedometer cluster in my instrument panel..

Before I open up the dash, I want to have the necessary bulbs on hand.

Can someone help me determine what bulbs I need, the number of bulbs I need,  and where to purchase them?

Your help will be greatly appreciated.

1964 Cadillac Coupe DeVille Convertible Speedometer Bulbs

Posted by Russell L Parr on April 1, 2022 at 9:15pm 0 Comments

I need to replace the bulbs for the speedometer cluster in my instrument panel..

Before I open up the dash, I want to have the necessary bulbs on hand.

Can someone help me determine what bulbs I need, the number of bulbs I need,  and where to purchase them?

Your help will be greatly appreciated.

Temperature gauge not working properly

Posted by SK on March 23, 2022 at 2:43pm 2 Comments

The temperature gauge of my 63 Eldorado does not work properly.

It goes slowly all the way up and stays there, while the true temperature is around 155-160 F (water in the radiator and/or the top of the thermostat housing).

Where should I start to solve the problem? The gauge itself, the temperature sensor, or the wiring? Or something else? The sensor is a new (aftermarket part)…

Continue

Videos

  • Add Videos
  • View All

© 2022   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service